464820907 Char-Broil Grill - Parts

This replacement grease cup is specially designed for use with Char-Broil grills. It is an authentic item that is sourced directly from original equipment manufacturer. The purpose of this tray is to collect the grease and other food particles from the food you are cooking. After each use it is recommended to clean this part with soap and...Read more water to avoid rusting. This item is made out of metal and it is sold individually. Please note, the grease cup clip/holder is sold separately.

This is an individual plastic wheel compatible with various models of outdoor grills. This wheel attaches to an axle rod at the bottom of the grill assembly, allowing you to move it around. If you find your grill difficult to move and notice that the wheel(s) do not rotate or move smoothly due to damage or warping, you will need to replac...Read moree this wheel. Consider ordering multiple wheels if you find that more than one is not moving properly. This wheel measures approximately 6 inches in diameter and has a 1 1/16-inch outer diameter and 3/8-inch inner diameter bearing. To replace this wheel, you only need to remove the pin that secures it to the axle rod. Then, you can slide off the old wheel and install and secure the new wheel in place.

This replacement heat tent is an authentic OEM sourced item that is designed for Char-Broil gas grills. It is secured over the burner tube to direct grease and drippings away which will help to cut down on flare ups tremendously. An extra benefit of these tents is that they help to add that "cooked on a grill" flavor to your food by vapor...Read moreizing the grease. Because tents tend to rust in the combination of heat and moisture they should be cleaned every time after each use with warm water and soap. This item is made from durable steel with porcelain coating and it is sold individually.

This is an authentic Char-Broil replacement part that has been sourced from the original manufacturer to be used with outdoor gas grills. The metal hinge connects to the rear of the firebox and is used to link the upper hinge to create a complete hinge that allows the lid to stay connected to the firebox. This item is available as an individual replacement part. A screwdriver is needed to install this item.