4627 - Parts

Clutch-Drive

This crankcase gasket is an OEM part direct from Briggs & Stratton. The composite material gasket is made for use with many small lawn and garden engines. This item is fitted between the crankcase and crankcase cover, providing protection from friction and leakage. A wrench, screwdriver and a socket set are helpful for making the installa...Read moretion. The crankcase gasket is sold individually. Please refer to the specific manual for additional repair and safety instructions.

This is an authentic Briggs & Stratton replacement part manufactured for use with small engines. The timing key is used to fit into the slot on the crankshaft and into the key-way on the timing gear. This allows the timing gear to rotate with the crankshaft. The timing gear is available as an individual replacement part, please see model diagram for associative parts.

This is an individual plastic wheel compatible with various models of outdoor grills. This wheel attaches to an axle rod at the bottom of the grill assembly, allowing you to move it around. If you find your grill difficult to move and notice that the wheel(s) do not rotate or move smoothly due to damage or warping, you will need to replac...Read moree this wheel. Consider ordering multiple wheels if you find that more than one is not moving properly. This wheel measures approximately 6 inches in diameter and has a 1 1/16-inch outer diameter and 3/8-inch inner diameter bearing. To replace this wheel, you only need to remove the pin that secures it to the axle rod. Then, you can slide off the old wheel and install and secure the new wheel in place.

It is a genuine item that is supplied by the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. This is a special component that helps to move the fuel through the lines. It provides an identical replacement for a faulty or a missing body-fuel pump that was installed o...Read moren a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part. This high-quality component is made of durable plastic and is sold individually, keep in mind the hardware to secure it is sold separately.

This is an original part from Briggs & Stratton. The fuel pump kit (used on 4 screw fuel pump mount carburetors) is composed of metal, plastic and cardboard composite. This kit is made for use with many small lawn and garden engines, and is fitted into the engine carburetor. This maintenance kit provides protection from friction and leaka...Read morege, and is sold individually. A screwdriver and a pair of pliers are often needed for the installation.

This is an authentic Briggs & Stratton replacement part, sourced from the original manufacturer for use with lawnmower engines. The special screw is commonly used to secure the engine's crankcase cover. This screw is sold individually, please note eight screws may be required.

The governor shaft retainer attaches to the governor gear. This part is made of metal and is sold individually. It is a genuine Briggs & Stratton and Toro replacement part for use in engines and lawn tractors. You may need a socket set and a wrench set when replacing this item. It may become broken and will need to be replaced.

The alternator connector wire is made out of plastic and metal. It is available as an individual replacement part. This genuine item is supplied by the original equipment manufacturer for use with engines, generators, lawn mowers, lawn tractors, and snowblowers made by Briggs & Stratton, Toro, Lawn Boy, and Murray. A screwdriver, a socket...Read more set, a wrench set, and a nutdriver might all be helpful during the installation of this part. It may become broken and will need to be replaced.

The retaining ring fits next to the pinion gear and helps to hold it in place. Keep in mind that this part is made of metal and is sold individually. It is a genuine item that is supplied by the original equipment manufacturer for use with Briggs & Stratton engines and Toro lawn tractors. During installation, a socket set and a screwdriver may be required to help replace this part.