460Z - Parts

It is an authentic OEM sourced item which is specially produced for use with snowthrowers, generators, and rear engine riders made by Murray, Briggs & Stratton, Snapper, and Simplicity. The nut is made of metal and attaches to the starter switch. During replacement, it may require a wrench to help install this part correctly. It may becom...Read moree broken or stripped and will need to be replaced. This part is available as an individual replacement.

This nylon-insert flange nut is designed for use on outdoor power equipment to securely fasten components exposed to vibration and torque. The built-in flange helps distribute load evenly without the need for a separate washer, while the nylock insert resists loosening during operation. It’s a simple, reliable replacement for maintaining safety, stability, and secure assembly across a wide range of equipment.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with riding lawn mowers from Husqvarna and Poulan. Cables can wear out or the connection point at the ends can snap and break off. This cable is used to replace a damaged or broken cable. This item to connects to the choke extension sprin...Read moreg and is used to open the choke when cold starting the engine and to close the choke when idling the motor. This item is sold as an individual replacement part. Needle nose pliers and a screwdriver are needed for this repair.

This is an authentic replacement part manufactured for use with riding lawnmowers. The plastic valve stem is used to allow air into the tire and to keep air from escaping the tire. This valve stem included the cap and is sold individually.

This OEM valve stem regulates air flow in and out of tires, allowing for inflation and deflation. It features an 11.5mm outer diameter, 31.75mm total length, and 22.35mm effective length. It is a metal valve with a threaded plastic cap, housed in plastic. To determine if a valve stem is broken, you can check for signs of damage or leakage...Read more. Signs of a broken valve stem include cracks, bends, or air leakage, which should be replaced to prevent tire deflation and operational issues. To remove the valve stem, fully deflate the tire first. Then, disconnect the tire from the rim to access the inner part of the rim. You may need to unthread any securing nuts if present. Use a pair of pliers to grip at the base of the valve stem and then unscrew it from the rim hole.

This is an authentic Snapper replacement part. The clevis pin is designed by the manufacturer for use in lawn tractors and riding mowers. This part is made of metal, and is generally used in securing the end of the deck lift rod. You may require pliers when replacing this part. This item is sold individually.

Knob-int thr .312-18

This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with riding lawnmowers. The special baffle is used to cover and protect the leading edge on the right-hand side of the mower deck. This item is available as an individual replacement part, please note the hardware used to secure the baffle is available separately.