My Orders
46-23 - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
water leaking when washing machine went to spin
-
William J from Prattville, AL
- Really Easy
- 30 - 60 mins
-
Screw drivers
removed two screw at the bottom of front panel and pulled down on panel to remove, determined water coming out splash seal, splash cover held on with plastic clips around cover. Removed two screws on back side of top and hinged top over removed splash cover and cleaned old seal out replaced with new seal.Simple job but could not find part
... Read more
s locally and found Partselect on internet and ordered parts, very friendly and knowledgible person, ordered parts and had them in three days, would very highly recommend. Thank You Joe Lumpkin
Read less
Was this helpful?
Thank you for voting!
leaking water
-
charles from san leandro, CA
- Really Easy
- 1- 2 hours
-
Pliers, Screw drivers, Socket set
removed all parts from trans shaft and replaced seal although had some difficulty removeing the agitator assembly due to age and mineral deposits but a little wd40 and tapping with a hammer helped
Was this helpful?
Thank you for voting!
When filling the washer Water ran out of it and flooded the floor.
-
Sheri from Wrightsville, PA
- A Bit Difficult
- More than 2 hours
-
Screw drivers, Socket set, Wrench set
Remove the agitator and the 2 bolts that clamp the spin drum to the shaft and pull up on drum the 2 seals are on the shaft right there. Pry up on the seals to remove them. Install all seals and Be sure to completely clean all parts before putting them back in the machine and re assemble the machine. The bad part of this job is if you hav
... Read more
e used powdered soap it took 3 hours to clean the parts before reassembly.
Read less
Was this helpful?
Thank you for voting!