46-21 Tappan Washer - Parts

Sold Individually.

Holds plated on Trunion .312-18 x 1.625.

This spacer is used in washers or a washer and dryer combo unit. Spacers are used to create space between cotter pins, lock nuts, hitch pins or to fill the space between machinery parts in a washer. This part goes between the timer knob and the dial in a washer to function effectively and provide protection. The length of this part is 6.3...Read more5 inches with a width of 5.25. The spacer has a height of 8.125 inches and the weight of 0.3 pounds. Refer to the manual provided by the manufacturer for further installation instructions and guidance. Remember to unplug your appliance from the power source.

This water inlet hose is used in washers. The hose connects the washer water inlet valve to the water supply in your home. There are two solenoids on the valve, which are referred to as coils, and there are two wires attached to each solenoid that should be labelled to ensure they are properly reconnected after replacing the new hose. Ove...Read morer time, your hose can begin to leak which can lead to floods. Replacing your hose earlier on can prevent this problem. Refer to the diagram provided by the manufacturer for installation instructions. Remember to unplug your appliance from the power source before beginning this installation project.

The tub ring seal or splash cover seal is used for washers. This part seals the tub cover to the outer one and prevents water leakage from around the tub ring. If your seal is damaged and you are experiencing water leakage, it is best to replace this part. Refer to the manual provided by the manufacturer for further installation instructi...Read moreons. Remember to unplug your washer from the power source before starting this installation process.

Sold individually.

This part is found between the pump and the motor shield and its purpose is to make sure that nothing leaks down the shaft into the transmission. Replace if washer is leaking.

This basket drive tube seal or upper lip seal is used for a top washer and is located on top of the transmission, below the agitator drive block. The tube seal functions as a protective tool to prevent water from leaking into the drive tube. The measurements for this seal are: 4 inches in length, 1 inch in height, and 0.01 lbs in weight. ...Read moreRemember to unplug your washer from the power source before beginning this installation, as a safety precaution. For installation instructions and accurate guidance, refer to the manual provided by the manufacturer.

This is a horizontal spring, but you may know it as a suspension spring, and it is a part for your washing machine. Its function is to stabilize the outer tub by keeping it balanced. In order to make this repair you will need a putty knife, and a Phillips head screwdriver. This spring is roughly 1 inch thick by 4 inches long, it is chrome...Read more colored, and has two hooks on either end to make your repair easier. Take note that this piece is sold individually.