My Orders
- Home
- 41741100000
- Instructions
41741100000 Kenmore Washer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Original bellow had 2 largish holes in the upper left quadrant; random leaking.
20 of 25 people
found this instruction helpful.
-
Michelle from Loves Park, IL
- Very Difficult
- 1- 2 hours
-
Pliers, Screw drivers
Bought new part. #1 Lesson learned: Always inspect the actual part number of the ordered/received part. Verify with number marked on the item somewhere. We did not do this and turned out we reinstalled a slightly smaller bellow (wrong part number received in shipment). We were able to fully install it but it was minutely not laying perfec
... Read more
tly around the diameter. So minor we did not notice. We did have great difficulty installing though. Anyway, after 1st test run, bellow already had developed a small hole in bottom right quadrant from rubbing on the drum. Left a bunch of gray powdery debris on the drum too. We did not realize error until that point. Took bellow off again to verify part number on it. It was wrong. That explained why the door was so very tight to close and difficult to open. Other than all that, use the video to do the install. It was free to view and easy to follow.
Read less
Was this helpful?
Thank you for voting!
ELECTRONIC COMPONENT
4 of 4 people
found this instruction helpful.
-
Elmer from JACKSONVILLE, FL
- Very Difficult
- More than 2 hours
Still waiting on the part. It apparently is on back order and I'm still waiting to get the part to try and repair the dryer.
I estimate an hour to replace the part if I ever get the part.
I estimate an hour to replace the part if I ever get the part.
Was this helpful?
Thank you for voting!
washer stops in middle of cycle and E53 appears on the screen
3 of 3 people
found this instruction helpful.
-
Baruch from HURLEYVILLE, NY
- A Bit Difficult
- 30 - 60 mins
-
Pliers, Screw drivers
1 you have to order a new motor control board
2 unscrew the back panel
3 unscrew the top panel
4 unscrew the bracket
5disconnect the old motor control board
6 connect the new motor control board
2 unscrew the back panel
3 unscrew the top panel
4 unscrew the bracket
5disconnect the old motor control board
6 connect the new motor control board
Was this helpful?
Thank you for voting!
While using washer a E9F code appeared and stopped working.contacted parts select trouble shooting site they told me what it was ordered the part they were right on!back washing again thanks so much for the help!
1 person
found this instruction helpful.
-
Stephen from DELTONA, FL
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers, Socket set
Did it with no problems at all just followed the video step by step worked great done in 1hour!
Was this helpful?
Thank you for voting!
not cycling
0 of 1 people
found this instruction helpful.
-
donna from gardnerville, NV
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers
put new part did reset on main controles
Was this helpful?
Thank you for voting!