4018922980 Kenmore Microwave - Instructions

pressed clip into hole on top of front panel. first remove two philip screws that hold filter so you can lift top up.

1) Unplug power cable from dryer.
2) Remove the 2 screws that secure the chute for lint filter screen with
Phillips head screwdriver.
3) Remove the lint filter screen.
4) Depress plastic locking clip on each side with putty knife to release
tension and lift up top panel to clear the locking clips. Each ... Read more locking
clip is located 2-1/2 inches from the front edge of side panel.
5) Lift the top panel and lean against the wall for support. If dryer top
panel cannot be raised all the way due to cabinet(s) above, tape
the dryer top panel to cabinet above or have somebody hold the
top panel for temporary support.
6) Install the new metal locking clips. Ensure that the elongated tab
of the metal locking clip is towards the front of dryer. Compress
locking clip lightly with pliers and push down into the hole.
7) Lower the dryer top panel and press it down in place over the metal
locking clips for a tight fit.
8) Reinstall the 2 screws to secure the lint filter chute.
9) Reinstall lint filter screen.
10) Reconnect power cable for dryer.
11) Turn on dryer and inspect that all dryer panels (top, sides and
front) are tight and secured.
Repair Duration: 5 minutes

removerd screws open control panel remover old timer install new timer replace cover on control panel repace screws done

The 5-cycle timer eventually failed on our Amana dryer and these were the symptoms leading up to the failure. First symptom was the timer would emit a squeak or squeal when the timer knob was pushed in. Then more recently the panel breaker kept tripping out. I shut the breaker off, pulled the plug, and dismantled the dryer panel to loo ... Read more k at the timer. No noticeable fault or failure. Took a chance, ordered the replacement timer from PartSelect, and before installing wrote all the model and other numbers off both the old and new timers. They matched (Model 275 BEF) & (Kingston Model 275). Pulled the wire tabs one at a time off the old timer, and pushed onto same tab on new timer. Re-assembled the panel, plugged in the dryer, and turned the breaker on. Put the dryer through a few test drying cycles and it ran like new. The timer was a perfect fit and replacement, and all problems were eliminated. Runs like new!