EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

3RLE Whirlpool Dryer - Parts

25 - 36 of 267

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Dryer Retainer Spring Clip – Part Number: WP3388229
$9.62
In Stock
Drum Support Shaft - Rear Shaft with Left Hand Threads WPW10359272 – Part Number: WPW10359272
$50.56
In Stock
Drum Support Shaft - Rear Shaft with Left Hand Threads WPW10359272
★★★★★
★★★★★
(2)
Part #WPW10359272
Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.
Drum Support Roller Shaft - Right Hand Threads – Part Number: WPW10359271
$50.56
In Stock
Drum Support Roller Shaft - Right Hand Threads
★★★★★
★★★★★
(1)
Part #WPW10359271
This front shaft with right hand threads is used in dryers. The shaft and the drum support rollers ride on to support the drum. If your shaft has flat spots and the rollers do not spin, replacing the shaft can solve the problem. The tools needed for this repair are: 5/16 inch socket or nut driver, 1/4 inch socket or nut driver, small flathead screw driver, channel-lock pliers, 9/16 inch socket. Remember to unplug your appliance from the power source before beginning this installation project. Refer to the diagram provided by the manufacturer for further installation instructions.
Dryer Terminal Block – Part Number: WP3397659
$19.30
In Stock
Dryer Terminal Block
★★★★★
★★★★★
(1)
Part #WP3397659
This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately
Dryer Blower Housing Seal – Part Number: WP697770
$9.62
In Stock
Dryer Blower Housing Seal
★★★★★
★★★★★
(4)
Part #WP697770
This part seals between the blower housing and the blower housing cover.
Door Switch – Part Number: WPW10237959
$44.95
In Stock
Door Switch
★★★★★
★★★★★
(11)
Part #WPW10237959
This is a door switch that is compatible with models of dryers. The door switch in a dryer is designed to communicate with the control board when the door is open or closed. If this door switch is damaged or not working properly, it will cause your dryer to incorrectly detect whether the door is closed and will normally result in your dryer not being able to start or stopping a cycle randomly. This door switch is made entirely of plastic with the door switch tab on one end, and its wire harness on the other. Replacing this door switch is easy but does require some slight disassembly of your dryer, which you will need a screwdriver and wrench for. This door switch is an OEM part and does not come with its necessary securing screws.
Leveling Leg Locking Nut – Part Number: WP3359452
$7.47
In Stock
Leveling Leg Locking Nut
Part #WP3359452
The leveling leg locking nut is an OEM replacement fastener for use in dryers and washers. It has a head diameter of 3/8 inches and a thread pitch of 16 threads per inch. The nut secures the leveling legs which helps to stabilize and level the appliances when they are placed on uneven surfaces. The nut ensures that the leg is stable and does not move during operation. Over time, the threads on the nut may become stripped, or the nut can corrode and break rendering it unable to secure the leveling legs. A faulty nut will cause the appliance to shake and vibrate excessively, and potentially damage the floor and its internal components. It is recommended to replace both the leveling leg and nut at the same time. Use a wrench or pliers to loosen and remove the old locking nut from the leveling leg. Thread the new nut on to the leveling leg and ensure that it is tightened securely. Be careful not to overtighten and damage the threads. Gently shake the appliance to ensure that it is stable and level. Each nut is sold individually.
Spray Paint - 12 oz. - White – Part Number: 350930
No Longer Available
Spray Paint - 12 oz. - White
★★★★★
★★★★★
(3)
Part #350930
Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a protective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.
Dryer Spring – Part Number: WPW10446781
$22.52
In Stock
Dryer Spring
★★★★★
★★★★★
(2)
Part #WPW10446781
Introducing the Whirlpool Dryer Idler Spring, a genuine OEM part designed for some models of Whirlpool, KitchenAid, Maytag, Jenn-Air, Amana, Inglis, and Magic Chef clothes dryers. This essential product functions to hold the idler pulley tight against the drum belt, enabling the belt to turn smoothly and efficiently. Specifically designed for the idler pulley arm in dryers, it ensures optimal performance of your appliance. Guaranteeing maximum durability and reliable performance, safety measures include unplugging your dryer before installation and wearing work gloves to protect your hands. Opt for the Whirlpool Dryer Idler Spring to maintain the effectiveness of your dryer. Please verify that this part is suitable for your model before ordering to counter any potential variations in size or shape.
WASHER – Part Number: W11236646
$22.52
In Stock
WASHER
★★★★★
★★★★★
(2)
Part #W11236646
This part is located on the drum roller support shaft in your dryer appliance. The exterior of the washer is 1 inch in diameter with a hole in the middle and is made of metal. They are installed alongside the drum support rollers and idler pulleys. If you notice that your dryer is making an unusual sound it could be due to the washer becoming loose on the drum support. They help prevent the rollers and pulleys from bumping up against the brackets they are installed on. If you are replacing the rollers, we suggest you replace the washers at the same time.
Terminal Block Screw Kit – Part Number: 279393
$30.53
In Stock
Terminal Block Screw Kit
★★★★★
★★★★★
(2)
Part #279393
This kit includes 3 screws and 3 nuts.
Washer Knob Springclip – Part Number: WP688805
$9.62
In Stock
Washer Knob Springclip
★★★★★
★★★★★
(2)
Part #WP688805
Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.
25 - 36 of 267