3LA5580XSW1 Whirlpool Washer - Parts

Sold individually.

Found on the water inlet valve.

Used to drain water.

This seal is for the top of basket drive tube shaft.

Used to put a space between the cabinet and the top of the washer.

This hose can handle hot or cold water and is five feet long.

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read moreotective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.

This screw is sold individually.

This is the bearing for the lid hinge. Sold individually.

This spanner nut, also referred to as a lock nut, is a critical component that secures the inner tub to the drive block in large-capacity washers. Featuring a right-hand thread, it ensures the tub remains firmly in place during wash and spin cycles, preventing excessive noise, shaking, or vibration. A worn or damaged nut can lead to poor ...Read moreperformance and operational issues. Installation requires basic tools and disassembly; always disconnect power and water supply before beginning the repair.

This washer agitator base is a genuine OEM component designed to support the agitator’s movement during the wash cycle. Positioned beneath the auger, it creates the back-and-forth motion that moves clothes through water and detergent, helping to loosen dirt and improve cleaning performance. The base works in coordination with the washer’s...Read more motor to maintain consistent agitation. Common symptoms of a failing agitator base include the agitator not moving, poor cleaning results, excessive vibration, or unusual noises during operation. Replacement is recommended when the part is cracked, worn, or no longer functioning properly.