38BL21 Waring Blender - Parts

It is a genuine OEM supplied replacement hardware that is specially produced for Waring blenders. This is the hex nut that is secured on the bottom of the blender jar. Please note one durable metal item is included per order.

This is a genuine replacement part sourced directly from the manufacturer. The crimp connector is commonly found in Waring juicers, blenders, and waffle makers. This part is made of high-quality plastic, with a metal crimping ring inside. It is used to join components in the electrical system of the machine. When replacing this item, ...Read moreyou may be able to remove the old part using pliers, or you may need to cut the wire as close as possible beneath the crimp. The new part can then be installed using a crimping tool. This item is sold individually.

This is a genuine Waring replacement part that is supplied by the original manufacturer for use with blenders. The switch is used to relay electricity from the power cord to the motor. This switch is a three position switch that includes a high, low, and off settings. The switch is available as an individual replacement part.

This is an authentic Waring replacement part manufactured for use with blenders. This lid is the outer ring used to seal the top of the blender jar. The outer lid is sold individually, please note the center lid is sold individually.

This is a genuine Waring replacement part. The screw is commonly found in blenders and food processors. This part is made of metal, and comes with two lock washers already attached. It may be used in different locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to t...Read morehe parts diagram to be sure of ordering the correct part. You will require a screwdriver when replacing this part. This item is sold individually.

This is a genuine manufacturer sourced replacement part used on Waring blenders. The coupling is the part of a blender that transfers power from the blender's motor to the blade assembly. Over time, the teeth on blender coupling wear down until they no longer engage properly on the blade assembly. This coupling is made out of plastic and it is sold individually.

This is an authentic manufacturer-sourced replacement container which is specially designed for use with Waring blenders. The purpose of this container is to hold the ingredients that are being blended, please note the cover and the blade are both sold separately. It is a high-quality component which is made of durable plastic and is sold individually.

The blending assembly goes inside the container. This part is available as an individual replacement. It is a genuine Waring replacement item for use in blenders. A set of pliers might be required during the replacement of this part. It is made out of metal and will need to be replaced if it breaks or bends.