38581 - Parts

This 1/4-20 x 3/4-inch hex-head screw secures parts on compatible outdoor power equipment. It is made from Grade 5 steel and has a yellow zinc finish for added rust resistance. Check the equipment model and parts diagram before ordering.

This is a genuine manufacturer supplied replacement fuel filter. It is specially produced for use with Toro snowthrowers. This is a plastic fuel filter that is sold individually. Its purpose is to filter out any contaminants from the fuel before it goes into the engine. It will over time get clogged and restrict the fuel from getting to t...Read morehe engine. To replace this filter you should only need pliers to remove and install the clamps that secure fuel lines.

It is an authentic OEM component which is made for Toro snowthrowers. This special spacer ensures a tight fit helping to secure the blade-rotor. It provides a high-quality replacement for a missing or a damaged hardware that was installed on a new unit. Check the diagrams of your specific model for the exact location of this component. It...Read more is made of durable metal and is sold as an individual item. Replacing it is a simple task that may only require a wrench set. Simply screw that holds the blade-rotor and replace the old spacer with the new.

The flat washer is an OEM replacement part that provides a wide surface area to distribute the load of a bolt or a screw when it is installed. This protects the part being fastened from getting damaged or deformed and provides a more secure fit for the bolt/screw. This flat washer is made of steel and has a diameter of 0.375 inches and a ...Read morethickness of approximately 0.063 inches. To replace the flat washer, first unthread the bolt/screw before using a flathead screwdriver to carefully pry it off. Clean the area, place the new flat washer in position, and thread the bolt/screw back on. Sold individually.

This is an authentic replacement ignition switch. It is sourced from original manufacturer and it is specially designed for use on Toro snow throwers/blowers. It allows user to start their equipment using a simple ignition turn key (sold separately). This switch has a plastic body and two metal wire terminals/prongs. Includes one (1) swit...Read morech per order. Replacing this switch is a simple task that generally does not require any tools. • Reach under cover/housing and disconnect cord from the old switch • Pull out switch • Secure new switch in place • Reconnect power cord and test the unit

It is a genuine OEM sourced replacement screw which is specially designed for use with Toro snowblowers. This hardware has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams of your model for the correct location and use of this item. It is a high-quality component which is made of du...Read morerable metal and it is sold individually, you will need a Phillips screwdriver to install or remove it.

This replacement hardware is sourced from original equipment manufacturer for use with Toro snowthrowers. It is standard hardware which has multiple applications, please refer to appropriate diagrams for correct location and use of this locknut. This part is made from durable metal and it is sold individually.

This is an OEM part directly sourced from the manufacturer for use in Toro snowthrowers and Briggs & Stratton engines. The governor spring is made out of metal. During the installation process, a set of pliers might be needed to replace this item. Over time this part may break or bend and will need to be replaced. This item is available as an individual replacement part.