EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

3828 - Parts

1 - 12 of 321

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Run Capacitor – Part Number: WR55X24064
$61.39
In Stock
Run Capacitor
★★★★★
★★★★★
(7)
Part #WR55X24064
Support steady compressor operation with this refrigerator run capacitor. It provides the electrical phase shift needed for the compressor motor to run properly as the cooling system operates. A failing capacitor may contribute to humming, difficulty starting, interrupted compressor operation, or rising compartment temperatures. Visible swelling, leaking, or burned terminals may also indicate damage. Unplug the refrigerator before accessing the component. Capacitors can retain an electrical charge after power is disconnected, so follow approved discharge procedures and avoid touching or shorting the terminals. Record the wire positions before replacement. This is an OEM part sourced directly from the manufacturer.
Door Shelf Retainer Bar End Cap – Part Number: WR2X9162
$32.64
In Stock
Door Shelf Retainer Bar End Cap
★★★★★
★★★★★
(6)
Part #WR2X9162
This is a replacement shelf bar end cap. The end cap connects to the shelf bar on either side, and then snaps into position on the freezer door. This will allow you to store items in the freezer door. It is a little more than 2 inches long and is made of white plastic. To replace the end cap, you can simply depress the locking tab and remove the entire bar and end cap assembly. Then, use a flat blade screwdriver to depress the locking tab, and the endcap will detach. Finally, snap the new end cap locking tabs into place, and snap the bar assembly back onto the freezer door. This product is sold individually.
Light Socket – Part Number: WR2X9391
$23.16
In Stock
Light Socket
★★★★★
★★★★★
(19)
Part #WR2X9391
This part is a replacement light socket for your refrigerator. It connects to the power source, and holds the light bulb. If the light in your refrigerator is not working, you could have a faulty socket. It is important to determine if the light bulb is simply burned out, or if the socket is causing the issue. Be sure to disconnect your refrigerator from the power source before you begin this repair. This socket is black in color and is sold individually. This is an OEM part sourced directly from the manufacturer.
Refrigerator Defrost Timer – Part Number: WR9X483
$41.70
In Stock
Refrigerator Defrost Timer
★★★★★
★★★★★
(1)
Part #WR9X483
This refrigerator defrost timer will cycle for thirty minutes after every ten hours of run time.
Evaporator Motor Kit – Part Number: WR60X203
No Longer Available
Evaporator Motor Kit
★★★★★
★★★★★
(2)
Part #WR60X203
This part is located in the back of the freezer and circulates air over the refrigerator coils. These coils will convert the heat into cool air which is then circulated.
Relay PTCR - 3 Wire – Part Number: WR07X10055
No Longer Available
Relay PTCR - 3 Wire
★★★★★
★★★★★
(3)
Part #WR07X10055
Also known as the Start Relay. The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.
Screw - #10 – Part Number: WE2M174
$19.50
In Stock
Washer – Part Number: 107-3844
$6.55
In Stock
Washer
Part #107-3844
A washer is used for things such as load distribution, stability, alignment and protection for whatever equipment it is fastened between. This curved washer, also known as a wave washer or spring washer, is made of metal and features a curved design that allows for applications in settings where objects being fastened together are also curved or to exert a continuous level of tension. This washer measures approximately 1-inch in outer diameter and 1/3-inch inner-diameter and is compatible with and used on equipment like snowblowers, chainsaws and lawnmowers. This washer is installed between a round fastener or knob to better secure them together and if you notice that where the washer is normally connected is loose or vibrates excessively, this washer likely needs replacing. Depending on your model the replacement process may appear different, but it is just as simple as placing the washer between two things that are connected and securing them tightly.
Fan Blade with Clamp – Part Number: WR60X123
$87.98
Special Order
Fan Blade with Clamp
Part #WR60X123
This blade attaches to the evaporator motor.
Knob-handle – Part Number: 106-4161
$7.32
In Stock
Knob-handle
Part #106-4161
Genuine OEM replacement part used on Walk Behind Mowers and Snowblowers. This is a Plastic Knob with a Metal Bushing inside. Does not ship with screw or washer these parts are sold separately. Replacing this part is very easy and it does not require any additional tools.
Nut-lock, Ni – Part Number: 3296-29
$6.55
In Stock
Nut-lock, Ni
Part #3296-29
The Ni Lock Nut (Nylock Nut) is a Silver, 5/16x18, individually sold metal nut. It can be adjusted and replaced using a wrench or socket and torque wrench to the manufacturer specfications, and is used to secure the sheer pin in place on the augur. These nuts are a one time use part due to their locking mechanism. You'll know the nut has broken because the augur will not spin, and this is when the part should be replaced. Customers found this to be an easy repair.
1 - 12 of 321