3639714217 Kenmore Refrigerator - Instructions

Removed old Ice maker and replaced with new Ice maker.

If a 74 year old guy can install an ice-maker in a 20 + year old fridge in 20, or so, minutes it must have had good pictures and BIG PRINT. Working quite well at this time!

I removed the lower screw (not needed for the new icemaker), loosened the 2 top screws, unplugged the wire harness and removed the old icemaker. Unpacked the new icemaker assembly from the box, wiped the ice cube depressions to remove any debris, snapped on the water tube adapter, hung the new assembly on the 2 loosened upper screws and t ... Read more ightened the screws. The wire harness required the supplied pigtail plug which made the wire assembly long and awkward to replace the ice bucket/dispenser assembly, plugged it in and was done. It took a total of about 10 minutes for the entire operation and had a full bin of ice cubes within 36 hours and was ready for the ice dispenser/crusher in the freezer door. Easy install!

Used the nutdriver to loosen two screws, life out ice maker, disconnect electric plug and put aside. Placed the new icemaker on the loosened screws, plugged in electric connector and tightened screws. Used small level to verify that unit was level.Waited about two hours for first cubes to be released into tray - has been working fine si ... Read more nce!

it was slowing cracking for a long time, and repairs with duct tape and crazy glue were a futile attempt to avoid the inevitable; a new part altogether! Well a few moments searching your site for the exact piece were all that was needed. With 48 hours of placing the order I had it in my apartment and just slipped it into place! it was a ... Read more piece of cake!Thank you so much!

Removed the Ice maker from the freezer because the light was not on. Disassembled ice maker, found printed circuit board had shorted across two posts because the board was black in that area. Bought new ice maker assembly, installed in less than five minutes, making Ice fine.

I'm not at all techie, but your site made it easy for me to find the part I needed. The part arrived within 2 days, and walla I installed and all is good.

Thanks, I only wish every internet search was this easy.

Removed the drawers.Took out old cover by tilting up,Put New cover back on Tilting again to set it in ,brought it down on its rests and replaced the drawers.

put the new one in that was all there was to

Set it, and forget it. That easy.

removed old ice maker, obtained part number from it. went on line ordered new ice maker at 10:45 in the morning, at 3:00 the nexte after noon new icemaker was in hand. took about 5 minutes to install new ice maker. works perfect. would do business again with this company.

Removed the old cracked shelf and slipped in the new one. Fit perfectly. Should have done this years ago !!!!

First I removed the old cover, and the cans of soda I was using to hold it up. Then I put the new cover in, and snapped it in place. This took less than a minute, and could not have been easier. The replacement cover fits perfectly. Thanks!!

The new one not only arrived faster than I expected but it was also a lot sturdier, nice shape and the fridge looks cleaner. Also it offers better support for what I store right on it.

same