My Orders
- Home
- 3638685780
- Instructions
3638685780 Kenmore Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
ineffective frige door gasket due to stretching
8 of 10 people
found this instruction helpful.
-
Anita from Shawnee, OK
- Easy
- Less than 15 mins
I pulled off the old gasket and pressed in the new one. That's it!
Was this helpful?
Thank you for voting!
mositure and tempature
8 of 11 people
found this instruction helpful.
-
Mark from Cheraw, SC
- Easy
- 30 - 60 mins
First the Kenmore refrigerator was listed as most parts as not available on the Sears web site.
The old gasket was split in several places and moisture and mildew was part of the clean up. Because of the cold weather at the time of shipment the note about using warm water to soften the gasket so it would be more pliable was extremely ... Read more helpful.
I was also reversing the door swing and found that it was not that hard , it took about 45 minutes and was done the 24ft frig is now working great
Thank
Mark
The old gasket was split in several places and moisture and mildew was part of the clean up. Because of the cold weather at the time of shipment the note about using warm water to soften the gasket so it would be more pliable was extremely ... Read more helpful.
I was also reversing the door swing and found that it was not that hard , it took about 45 minutes and was done the 24ft frig is now working great
Thank
Mark
Read less
Was this helpful?
Thank you for voting!
leaking water from casket seal
1 person
found this instruction helpful.
-
Winston from BRONX, NY
- Really Easy
- 15 - 30 mins
Remove old gasket by pulling out one corner at a time and Installing it by placing it in the grove.
Was this helpful?
Thank you for voting!
slide was broken
0 of 1 people
found this instruction helpful.
-
Laura from Garland, TX
- Easy
- Less than 15 mins
-
Screw drivers
I took the drawer and shelf out,unscrewed the old slide, then screwed the ne wone in. Put the shelf back in and then slid the drawere right in!
Was this helpful?
Thank you for voting!
Broken drawer slide
-
John from Cloverdale, CA
- Really Easy
- 15 - 30 mins
-
Screw drivers
Removed slide from frame and replaced slide. Simple and easy.
Was this helpful?
Thank you for voting!
part did not fit.
-
James U from Pawleys Island, SC
- A Bit Difficult
- 15 - 30 mins
-
Nutdriver
was able to grind the edge to map it fit
Was this helpful?
Thank you for voting!