- Home
- 36315676000
- Instructions
36315676000 Kenmore Dishwasher - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Dishwasher would not run with the door completely latched.
6 of 7 people
found this instruction helpful.
-
James from Sergeant Bluff, IA
- Really Easy
- Less than 15 mins
-
Screw drivers
I removed the scews holding the inside door to the outside door section. Once removed I removed the 2 screws that held the switch to the door. After removing this switch I had to open it up to expose the four wires on the switch. I reattached the four wires to the new switch closed it up and placed it on the door with the 2 screws.
... Read more >Replaced the inside door. Job finished with the switch working and the dishwasher operating as per the factory standards.
Very easy job and by doing it myself I saved money on a service call.
... Read more >Replaced the inside door. Job finished with the switch working and the dishwasher operating as per the factory standards.
Very easy job and by doing it myself I saved money on a service call.
Read less
Was this helpful?
Thank you for voting!
Door latch broke
5 of 5 people
found this instruction helpful.
-
Barbara from TAMPA, FL
- Really Easy
- Less than 15 mins
-
Screw drivers
Removed the old one from its slot and slid the new one into it.
No instructions needed.
No instructions needed.
Was this helpful?
Thank you for voting!
Latch was broken so dishwasher wouldn't run
3 of 3 people
found this instruction helpful.
-
Rhonda from CANTON, GA
- Easy
- 30 - 60 mins
-
Screw drivers
I watched several YouTube videos on how to make the repair. It looked very easy but sometimes professionals, because they've done it before, don't point out small tips that would help a DIY homeowner. The latch goes easily into the inner door slot but there's nothing to hold it there. The videos show the inner and outer door being closed
... Read more
together without showing that you have to hold the latch in place while bringing the outer door up to meet the inner door. Any movement of the inner door makes the latch fall out. So I would say it took me 5 times longer to do this repair than it would if I was doing it again.
Read less
Was this helpful?
Thank you for voting!
Dishwasher would go on and off during operation
2 of 2 people
found this instruction helpful.
-
Kenny from CARUTHERSVLLE, MO
- Very Easy
- Less than 15 mins
-
Screw drivers
Took screws out of door panel to get to the latch and replaced old latch with new one. Super easy
Was this helpful?
Thank you for voting!
door latch broken
2 of 2 people
found this instruction helpful.
-
Thomas from COLUMBUS, GA
- Really Easy
- 15 - 30 mins
-
Screw drivers
I watched the convenient video and saved an old machine that I've grown to love. Plus I didn't have to pay a repair service or have to buy a new machine.
Thanks GE,
T. Dunn
Thanks GE,
T. Dunn
Was this helpful?
Thank you for voting!
Faulty Dishwasher Door Latch
-
cliff from knoxville, TN
- A Bit Difficult
- 30 - 60 mins
-
Screw drivers
Had to install a new door latch. The installation itself is really quite simple involving removing (separating) the inner door panel to access the latch assembly. The latch is removed by simple push through one slot with a screw driver and the new unit basically pops in through grooved slots. However, I did find it quite helpful to first
... Read more
(and during) review a YouTube video illustrating the replacement. Although it is largely a simple procedure, for the first-time "installer" there are still a few tricky nuances to be aware of.
Read less
Was this helpful?
Thank you for voting!
Door latch would not lock dishwasher door
-
Betty from Flintstone, GA
- A Bit Difficult
- 30 - 60 mins
-
Screw drivers
I unscrewed the front of the door almost to the bottom hinges and removed the latch. Went on line and ordered a replacement. The replacement arrived in a couple days (yeh), was identical to the one I had removed. I could have used another hand but went ahead and replaced it myself. It worked perfectly and I screwed everything back in plac
... Read more
e. I'm a 73-year-old female, good at taking things apart but not always good at putting them back together but will try anything. Was elated that I could repair it and it actually worked. Great service from your company!
Read less
Was this helpful?
Thank you for voting!