362S Husqvarna Chainsaw - Parts

This item is a genuine Husqvarna replacement part and it is sourced from the original manufacturer to be used with chainsaws. The metal bushing fits into the connection point on the bottom of the handguard and is used to aid the bolt in securing the guard. This item is available as an individual part.

This is an original Husqvarna replacement part manufactured for use with chainsaws. Some ignition models do not include the spark plug connector also called a spark plug boot, it is recommended to inspect the spark plug boot or replace it when servicing the ignition module. The rubber spark plug connection kit includes the coil spring. Th...Read moree coil spring has a sharp end that pierces the insulation of the ignition module\'s wire, and it is the coil spring that makes contact to the wire. This spark plug connection kit is sold individually.

This is an Authentic OEM sourced replacement part designed for use with Husqvarna Chainsaws. This is the Hose that delivers fuel from the Tank to the Engine. It is made out of Rubber and it is Sold Individually. Please note Fuel Filter is Sold Separately.

This screw is an authentic high quality item that is specially produced for use on Husqvarna power equipment. It is a standard hardware which has multiple uses depending on the unit, please refer to appropriate diagrams for correct location and use of this screw. Note that one hex socket head screw is included per order, you will need a hex key also known as an allen wrench to secure or remove this item.

This is an original Husqvarna replacement part manufactured for use with chainsaws and power cutter saws. The throttle catch is located on the top side of the throttle handle and is used to engage the throttle when the throttle trigger is pulled. This throttle catch is sold as an individual replacement part, please see model diagram for associative parts.

This part is an OEM from Husqvarna. The protective clutch drum bearing is compatible with many chainsaw devices. The metal part is fitted between the clutch assembly and the crankshaft. This item is sold individually. A hex key and a pair of pliers are helpful for the replacement.

This is a genuine OEM part used on several chainsaw motors. The metal clutch spring is fitted inside the clutch assembly, assisting the motor with the idle system without driving the saw. Although three clutch springs are used in the clutch assembly, this item is sold individually. You will need a hex key and screwdriver for the installation.

This is an authentic OEM part. The Husqvarna chain catcher is compatible with many chainsaws. The metal component is a safety feature, providing protection from a damaged or broken chain. The chain catcher is fastened to the crankcase assembly. Please note the screw used to secure it is sold separately. The chain catcher is sold individually. A hex key is often required for the installation.

This cylinder plug is an original part from Husqvarna. Compatible with many chainsaws, the metal plug is sold individually. Fitted in the cylinder, this item covers the compression hole. Pliers may be required for the installation.

This decal is a genuine replacement part supplied directly from the original equipment manufacturer. It is commonly used with chainsaws. This decal should be replaced if it is beginning to wear. Replacing this decal will keep your machinery looking pristine. No tools are required to replace this part. Simply remove the backing and press into place firmly with your hands.

This is an authentic Husqvarna replacement part that has been sourced from the original manufacturer to be used with chainsaws and brushcutters. The diaphragm is part of the carburetor and is used to move fuel through the fuel system by using changes in pressure along the system. This item is available as an individual replacement part.

This is an OEM part sourced directly from the manufacturer. The starter assembly is commonly found in Husqvarna chainsaws. This is a complete assembly, including the starter handle and rope, with the pulley and spring, as well as the metal housing. It is used to trigger engine ignition. You may require a screwdriver when replacing this item.