36275201892 Kenmore Range - Instructions

Followed you tube instructions I found on line via parts select recommendations.

the electrodes on this model have to be removed before you can raise cooktop, once cooktop is raised remove wire from burner bracket, use needle nose pliers to squeeze bottom of clip,remove &replace with new parts.

My husband and I probably could have done the repair in 15 minutes except for the difficulty lifting up the range top, dropping the screws into the range where they could not be retreived, threading the thermostate into the little holes from the top to the inside of the oven and then trying to hook the range top back into place. Even with ... Read more all the difficulties we still accomplished the task in one hour. Thank goodness we had 4 extra screws that worked (actually only takes 2 but of the 6 we had, 4 fell into a place you could not reach into). Glue on the end of the screw driver finally kept the screws from falling into the black hole. It was an adventure and would do it again.

I put it in the same way tuck it out

Easy

Remove the old tubes. Lift the lid NO MORE THAN FOUR INCHES. !!!!! Feel for the connections on the switch ends and attach losely. Carefully ( with some slight bending ) attach tubes to the burners. Tighten all connections. Do not over tighten.
The tubes broke originaly because , attempting to clean the area I lifted the lid too h ... Read more igh.

remove old burner, put new in place

My son lifted up cooktop, unscrewed the front plate to gain access to old tube burners, removed and replaced with new parts.

These new pans fit perfectly.

Lifter the old items off and replaced them with the new ones.

take off top grates,place new one's in time 20 sec.

Removed the old caps and replaced with new burner caps. The stove top looks brand new. Thank you.

changed double burmer pans

replaced the parts

took off old ones and put on new ones