325C Husqvarna - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Would not start now runs great
6 of 6 people
found this instruction helpful.
-
JAMES from FAYETTEVILLE, AR
- Very Easy
- Less than 15 mins
Remove and replace
Was this helpful?
Thank you for voting!
Weed eater flooded constantly.
5 of 8 people
found this instruction helpful.
-
Richard from CHINA GROVE, NC
- Very Easy
- 15 - 30 mins
-
Nutdriver
Very simple repair...took the old carburetor off and installed the new one. After replacement, the weed eater fired up after the second pull. Cover, removed 4 bolts. Carburetor, three bolts. Removed two hoses, choke handle and installed. Order gasket...never hurts to replace gaskets. One other thing, most important...use premix fuel!!! I
... Read more
use it in all gas powered equipment now. Cleaner and does not gum up filters and carburetor.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Fixed up somebody's old trimmer they threw at the curb
5 of 11 people
found this instruction helpful.
-
Jeremy from DILLSBURG, PA
- Easy
- 15 - 30 mins
This trimmer was in relatively good shape. Somebody had thrown it out! They thought they had broke the rewind, but when I ended up taking it off, it sucked right back in. They also must have broke the vibration plate on the bottom. With the screws and plate I bought from here, plus a new head and service kit I got elsewhere , this thing r
... Read more
an like a champion again.
Read less
Was this helpful?
Thank you for voting!
Needed a couple washers and a spring broken drive sprocket
2 of 4 people
found this instruction helpful.
-
STEVE from COLBERT, WA
- Really Easy
- 30 - 60 mins
-
Nutdriver, Socket set
Machined new center hub for sprocket attatched it to sprocket restacked everything back together adjusted tracks going to change oil fire it up see how it all works
Was this helpful?
Thank you for voting!
Chunk of wood broke the lower plastic chute.
2 of 8 people
found this instruction helpful.
-
Jason from Cummington, MA
- Easy
- 15 - 30 mins
-
Screw drivers, Socket set
Removed belt cover. Unbolted upper chute mount and removed metal upper chute with cables still attached. Replaced plastic lower chute, 4 bolts and reassembled machine.
Was this helpful?
Thank you for voting!
part not same
4 of 21 people
found this instruction helpful.
-
Bruce from ALGOMA, WI
- Easy
- 15 - 30 mins
Ordered on/off switch. My switch had only one wire terminal. Replacement had two. I ran a wire from one to a screw as a ground. Switch worked fine.
Was this helpful?
Thank you for voting!