3210 - Parts

This is an authentic kit made for the lid on Weber grills. This is a 14-part set that includes two posts, two retaining clips, and ten hex nuts. The posts are used to secure the lid to the body of the grill while allowing it to swing freely as a hinge. The ends of the posts have small holes that the retaining clips slide into to keep them in place.

This is an original Weber part manufactured for use with outdoor grills. The control panel plugs with screws fasten the control panel to the side frame. Only two plugs are required to secure the control panel, and this set will include both plugs, and two screws, please note the set is sold individually.

This replacement burner tube set is supplied directly from original equipment manufacturer. It is commonly use on Weber grills. Burners are a key component of a gas grill because, it is where the flames would rise from. They are connected to control valves. This set includes three (3) stainless steel burner tubes, one (1) carry over tube ...Read moreand the hardware to secure the burners. Replacing burners is a simple task that should only require a wrench. • Make sure gas tank is disconnected • Remove screws securing the old burners • Disconnect old burners from control valves and replace them with a new burners • Secure burners using the included hardware and • Secure the carryover tube • Connect the gas tank and test the burners

This is a Genuine Weber replacement part designed for their Grills. Kit includes: push-button igniter, gas-catcher ignition chamber, white wire, black wire, and instruction sheet. Hassle-free installation enabled by easy-to-follow instructional guide

Collar

Spring extension

This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 16 Gauge • 15 Feet Long