3145 - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Washer pulsator was coming loose during wash cycle.
1 of 2 people
found this instruction helpful.
-
Kristen from Safford, AZ
- Really Easy
- 15 - 30 mins
-
Screw drivers, Socket set
Since the old pulsator had actually come off during a wash cycle, I was able to place the new one on easily. Tightened the screw with a socket. Then placed the new cap on. Before placing the new pulsator on, I was able to clean all the mold and hard deposits off the mechanism under the pulsator. The hard deposits were also scrapped from
... Read more
the pulsator holding (where the screw goes) which may have caused the problem to begin with.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Lid hinge pin receptor (MEF62462103) broken
3 of 8 people
found this instruction helpful.
-
John from TUCSON, AZ
- Really Easy
- 30 - 60 mins
Remove cover over associated hinge pin assembly and the hinge assembly behind it. With the lid open, remove 4 screws holding on the top assembly, lift and rotate it on its wire cable side and rest it on the machine top frame (it may be necessary to remove the 2 cable restrainers to gain enough play to do this - you will have to remove the
... Read more
large rear cover to accomplish this and be able to reinstall these restrainers). Remove 2 screws fastening the broken hinge pin receptor, install new unit, and fasten with these 2 screws. Install top assembly and a new/repaired hinge pin assembly (most likely the reason for the broken hinge pin receptor).. Replace cable restrainers and rear cover if it was necessary to remove them. Note: These hinge pin assemblies are sold as a set (1 left, 1 right; they are not interchangeable and are expensive). Time to do repair = about 30 minutes.
Read less
Was this helpful?
Thank you for voting!
could not get the 10 mm nut to loosen
1 of 2 people
found this instruction helpful.
-
Marilyn from THOMASTON, GA
- Very Difficult
- 30 - 60 mins
-
Nutdriver
Tried everything and could not get it out I just use mesh bags for washing at this time, but LG washing machine is the worst I have ever had
Was this helpful?
Thank you for voting!
WATER WAS NOT SHUTTING OFF
3 of 17 people
found this instruction helpful.
-
cathy. from etna, OH
- Really Easy
- 15 - 30 mins
-
Screw drivers
I HAD A CHAT WITH LG EXPLAINED THE PROBLEM . SAID IT WAS THE WATER SHUT OFF VALUE. V EVEN SENT THE PAGE WITH PART# TO ORDER ONLINE.
LOVE LG CHAT!!!
LOVE LG CHAT!!!
Was this helpful?
Thank you for voting!