30521 - Parts

This is an authentic Toro replacement part, sourced from the original manufacturer for use with outdoor power equipment. The woodruff key is used to link a shaft and pulley or gear to allow the either the pulley or gear to rotate along with the shaft. This woodruff key is available as an individual replacement part.

This is an authentic Toro replacement part manufactured for use with snowthrowers. The special screw is commonly used to secure idler pulleys either near the engine or on the frame. This screw is used with different models of snowthrowers and pulley this screw can vary depending on the model of machine. The screw is available as an individual replacement part, please see model diagram for part location and usage.

This is an authentic Kawasaki replacement part that is sourced from the original manufacturer to be used with four stroke engines. The rubber gasket fits above the threads on the oil fill cap and is used to seal the connection between the cap and the fill spout. This item is available as an individual replacement part, please note the cap is available separately.

It is a genuine OEM sourced replacement part designed for use with Kawasaki engines commonly installed on lawn and garden equipment. This item fits the crankcase and helps to provide an air tight seal to prevent oil leaks. Over time the material tends to deteriorate and crack eventually requiring replacement. It is made of high-quality rubber and it is sold individually.

This is an authentic replacement part manufactured for use with small engines. The head gasket is used to seal the connection between the cylinder head and the cylinder. It is recommended to replace gaskets when servicing the engine to ensure proper seals when reassembling the engine parts. This gasket is sold as an individual replacement part.

This is an OEM replacement part for Kawasaki and Toro engines. The recoil starter rotates the pulley and spins the crankshaft to start the engine. This part is made up of the recoil spring, the pull cord, the pull handle, and the outer housing. This part is made of plastic and nylon cord. For installation, you will need a screwdriver and a pair of needle nose pliers.