3043 - Parts

This genuine Kawasaki fuel pump is an OEM-sourced replacement part designed to ensure reliable performance and quality. It is intended for use with small engines and plays a vital role in circulating fuel through the system by responding to pressure changes within the engine. Built for durability and consistent operation, this fuel pump i...Read mores sold individually and is ideal for restoring proper fuel flow in compatible engine models.

This high-quality manufacturer-sourced part is made for use with Kawasaki engines commonly installed on lawn and garden equipment. It helps to provide a tight seal between the crankcase and the crankshaft. Over time it may wear out and begin to crack eventually causing oil leaks and requiring a replacement. This high-quality seal is made ...Read moreof durable rubber material and is sold as an individual component. You will need a wrench set to take the engine apart and perform the repair. For the exact location and the correct installation, refer to the appropriate diagrams of your model.

The Lock Nut is used to secure and lock parts in place. This is a gold, metal, individually sold part which can be installed with a wrench set, and socket set, and attaches onto various locations on a variety of equipment. If broken, damaged or worn, the part may be loose, and there may also be physical damage to the nut, at which time it...Read more should be replaced. Refer to your make, model and diagrams to ensure this is the correct part.

The circuit breaker attaches to the control panel and helps to stop overloads. This part is an OEM from Briggs & Stratton generators. This item is sold individually and is made of plastic and metal. A screwdriver might be required during the replacement of this part. It will require replacing if it breaks or burns out.

This flat metal washer fits onto the speed guide-selector and is available individually. Please note that more than one washer may be needed when replacing parts. It will need to be replaced if it becomes lost or broken and may require a wrench during installation. This is an OEM Toro part sourced directly from the manufacturer and used in snowthrowers.

The flat washer is an OEM replacement part that provides a wide surface area to distribute the load of a bolt or a screw when it is installed. This protects the part being fastened from getting damaged or deformed and provides a more secure fit for the bolt/screw. This flat washer is made of steel and has a diameter of 0.375 inches and a ...Read morethickness of approximately 0.063 inches. To replace the flat washer, first unthread the bolt/screw before using a flathead screwdriver to carefully pry it off. Clean the area, place the new flat washer in position, and thread the bolt/screw back on. Sold individually.

This is an authentic replacement part manufactured for use with Toro snowthrowers. The ni lock nut is designed to prevent from being unthreaded from vibration. This nut is used with several different models of snowthrowers and is used with various applications. The nut is sold as an individual replacement part, please see model diagram for associative parts.

The lock washer goes next to the flat washer and is made of metal. It is available as an individual replacement part. This genuine item is supplied by the original equipment manufacturer for use with snowblowers made by Toro and Lawn Boy. A wrench might be helpful during the installation of this part. This item may become broken and will need to be replaced.

This part is an OEM from Kawasaki. The head gasket is made for use with many 4 stroke engines. The cardboard composite gasket is fitted onto the cylinder head, providing protection from friction and leakage. This component is sold individually. To complete the repair, you will need a wrench and a screwdriver.

This is a original Kawasaki replacement part made for use with small engines. The purpose of this bolt is to secure fan housing. It is a hex head bolt and it is sold individually. Replacing this bolt you should use a properly sized socket wrench.

It is made of metal and is sold individually. The screw connects to the idler pulley. A socket set might be needed during the installation process. Over time this part may become stripped and will need to be replaced. This part is an OEM from Toro and Lawn Boy for use in snowthrowers, tillers, blower-vacuums, and lawn tractors.