30342 Toro Lawn Mower - Parts

This is an authentic Toro replacement part, sourced from the original manufacturer for use with snowthrowers. The metal washer is commonly used to disperse pressure put on the auger housing by the nut that fastens the chute retainer across a wider surface area. This bolt is sold individually.

This is an authentic Toro replacement part, sourced from the original manufacturer for use with outdoor power equipment. The woodruff key is used to link a shaft and pulley or gear to allow the either the pulley or gear to rotate along with the shaft. This woodruff key is available as an individual replacement part.

This is an authentic Toro replacement part manufactured for use with snowthrowers. The special screw is commonly used to secure idler pulleys either near the engine or on the frame. This screw is used with different models of snowthrowers and pulley this screw can vary depending on the model of machine. The screw is available as an individual replacement part, please see model diagram for part location and usage.

This is an authentic Toro replacement part, sourced from the original manufacturer for use with snowthrowers. The valve is part of the tire assembly and is used to regulate tire pressure by allowing air into the tire and preventing air from escaping. This valve is available as an individual replacement part.

This is an authentic Toro replacement part manufactured for use with lawn tractors. The fuel cap is used to seal the fuel intake port on the fuel tank. This fuel cap includes the fuel cap gasket that will ensure a good seal between the cap and the tank. This gas cap assembly is sold as an individual replacement part.

This is a genuine Toro replacement part. The lock washer is designed by the manufacturer for use in snow throwers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different washers used in the machine. Refer to the parts diagram to be sure of ordering...Read more the correct part. You will require a wrench when replacing this item. This part is sold individually.

This governor plate, also known as the governor control, is supplied by the original manufacturer for use in a variety of outdoor power equipment. It is a metal plate that works with the throttle linkage to allow the engine to maintain a consistent speed during operation. If the governor plate wears down or becomes damaged, you will notic...Read moree that the engine will stall under load, and the revolutions per minute (RPM) in your equipment will fluctuate, causing over-speeding or under-speeding as well as inconsistent power output, and performance. Therefore, it is critical to replace this part if it is no longer working, in order to continue operating your equipment. You can find the governor plate near the throttle linkage assembly in your equipment engine. Depending on your model, you may need to remove the air filter housing to access the plate. Disconnect the throttle linkage from the governor plate and remove the faulty governor plate. Place the new one in position, secure it with the appropriate fasteners, and reverse-assemble the rest of the engine components to complete your repair.