2925 - Parts

This is an authentic replacement part manufactured for use with outdoor power equipment. The clutch cover assembly is used to house the clutch drum and clutch. The cover assembly includes the mounting hardware and is sold as an individual replacement part.

Key-ignition indak

The Recoil Spring is a silver, metal spring which attaches inside the starter assembly. It is used to wind the rope back around the pulley after it has been pulled. If broken, the starter rope will not retract and the part must be replaced. This spring is rated "Medium" difficulty to install and will requires a screwdriver, pliers and a wrench set.

The Clutch Drum is a silver, metal part used to transmit power from the engine to the drive shaft. Installation is rated "Medium" difficult and will require a screwdriver, wrench set, and torx wrenches. This part attaches to the clutch assembly. If broken, the clutch will slip and you will lose drive power. If this happens, the part must be replaced.

This external retaining ring is a type of fastener used to secure components in various models of tractors. It is a genuine OEM replacement part provided by the manufacturer, also known as an E-ring or circlip, which is responsible for exerting pressure against components prevent it from dislodging. The ring is a circular metal part with ...Read moreprotruding tabs or ears that can be gripped for easy removal or installation. If the retaining ring wears down or becomes damaged, it will cause the equipment parts to become unstable or fall off resulting in loss of functionality, and damage. Use retaining ring pliers to compress the ring and slide it out of its groove. Align the new ring with the groove and slide it in. Each external retaining ring is sold individually.

This genuine manufacturer-sourced item is specially made for use with Murray, Snapper and Simplicity lawn and garden equipment. It is a special hardware that helps to provide a tight fit between connected parts. This is an identical replacement for a missing or a damaged component that was installed on a new unit. Make sure to refer to th...Read moree appropriate diagrams for your model to ensure the proper repair procedure. A wrench set might be needed to replace this part. One durable bushing is included.

It is a genuine manufacturer-sourced component which is specially made for use with Murray, Snapper and Simplicity riding lawn mowers and garden tractors. It is the part of the equipment that allows a user to engage and disengage the blades. Unfortunately, over time components will wear out and may begin to fail eventually requiring a rep...Read morelacement. Keep in mind this high-quality plastic body switch is sold individually. Please make sure to refer to the owners manual and the appropriate diagrams of your model for the correct location and application of this part.

This is a genuine Snapper replacement part, sourced directly from the manufacturer. The circuit breaker is commonly used in Snapper lawn and garden tractors. This part is made of metal with a plastic backing, and is used in the electrical system to shut down the device in case of electrical surge, protecting sensitive components. This item is sold individually.

The Push Cap Rod is a 1/2-inch metal metal cap which can be easily installed with a hammer and pliers. This manufacturer certified part comes in silver and is made of metal. This cap attaches onto an axle to help the wheel stay attached. If broken, the wheel will fall off and the part should be replaced.

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal washer is used to provide spacing between the steering spindle and the front axle assembly. This item is sold individually, please note two washers may be needed.