2784-20 (H58A) Milwaukee Angle Grinder - Parts

This is a genuine Milwaukee accessory that assists in performing the repairs needed by the models listed below. The wrench is a metal gripping tool that is used on nuts or bolts to assist in rotating them or keeping them from turning and is sold individually.

This is a genuine Milwaukee accessory sourced directly from the manufacturer that assists in performing the repairs needed by the models listed below. The wrench is a metal gripping tool that is used on nuts or bolts to assist in rotating them or keeping them from turning and is sold individually.

This is a 605RS ball bearing commonly used in hand-held tools like grinders. It is located within the rotor assembly of the grinder, facilitating smoother rotation and reducing friction between the rotor and its housing. Without this ball bearing, the rotor would rub against its housing, leading to premature grinder wear and decreased eff...Read moreiciency. Signs that this ball bearing needs replacement include excessive noise, vibrations, heat, and difficulty in rotation during operation. To prevent further damage to your grinder or other internal components, it is crucial to replace the bearing when any of these signs appear. Replacing this ball bearing will require grease and various screwdrivers. Start by disconnecting the battery and removing the side handle. Next, unscrew and disconnect the screws securing the main grinder housing to access the interior. Carefully remove the rotor. Extract the old bearing by first removing its retaining ring and then using a punch if necessary. Apply grease to the new bearing and insert it into the housing. Reinstall the rotor along with its securing screws, and then reassemble the grinder housing, including the side handle.

This authentic replacement part is sourced directly from original equipment manufacturer. It is commonly used on Milwaukee grinders. The purpose of this collet nut is to secure a collet which holds bits. Common reasons for replacing this item would be rounded nut, stripped threads or if it is lost. Includes one (1) 1/4" collet nut per order. Please note you will need a wrench to install or remove this item.

This is an Genuine OEM Approved replacement part used on Milwaukee Grinders. This part provides a grip for holding a bit in a tool. It is made out of Metal and is Sold Individually. This Collet is for using bits with 1/4" arbors only. Due to prolonged, heavy use a Collet may need to be replaced eventually. To replace this Collet you wou...Read moreld need to use a Wrench. • First you would need to remove the Collet Nut • Once the Nut is removed you can remove the old Collet • Place a new one in place • Tighten the Collet Nut back in place and your unit is ready to use 1/4" Bits