2741-059 (D30B) Milwaukee Pipe Tools - Parts

It is an authentic item that is made for use with Milwaukee copper tubing cutters. This component is supplied directly from the original equipment manufacturer. The spring is secured to the wheel axle and it applies tension on the cutting wheel. Over time it may wear out, lose tension or even break eventually requiring a replacement. One ...Read moredurable metal cutting spring is included. Make sure to refer to the appropriate diagrams and the owners manual of your model to ensure the correct replacement of this component. It is a simple repair that should not require any special tools.

This is an authentic OEM part. The Milwaukee carriage spring is compatible with copper tubing cutters. The spring is fitted in the gearcase housing, providing the necessary tension. This metal item is sold individually. A hex key and a pair of pliers are helpful with the removal and replacement.

The cutter head is a genuine OEM sourced part which is specially designed for use with Milwaukee nibblers and shears. A screwdriver may be helpful when replacing this item. It is made of metal and will need to be replaced if it breaks. This is available as an individual replacement part but includes the screws.

This is an authentic Milwaukee replacement part, sourced from the original manufacturer for use with copper pipe cutters. The plastic carrying case is used to store and to transport the entire pipe cutter unit. This carrying case is available as an individual replacement part, please see illustrated part list for associative parts.

This copper cutter wheel is supplied by the original manufacturer for use in copper tubing cutters. Each pack includes two wheels. The cutter wheel is a circular steel blade with a black oxide finish, specifically designed to slice through copper tubing. It has a sharpened edge and a hole in the middle, which is mounted onto the adjustabl...Read moree spindle. The wheel allows for clean and accurate pipe cuts by clamping the cutter onto the pipe and rotating it until the pipe is severed. Over time and with frequent usage, the copper cutter wheel may become dull, crack, or become dislodged. When the cutter wheel fails, it will result in uneven or rough cuts, damage to the pipe or it may not cut at all. To remove the faulty wheel, you will need to disassemble the cutter head assembly. Remove the old wheel and insert the new wheel in the same orientation. Secure it in place with the appropriate fasteners and reassemble the cutter head assembly.

This is an authentic Milwaukee replacement part that has been sourced from the original manufacturer to be used with copper tubing cutters. The PCBA switch is used to relay electricity from the battery to the motor assembly. This item is available as an individual replacement part.

This item is an authentic Milwaukee replacement part that has been sourced from the original manufacturer to be used with copper tubing cutters. The e-clip is intended to be used to secure a part assembly along a shaft or pin. This part is priced as a single item.