2657-059 (F68B) Milwaukee Impact Driver - Parts

This is an authentic Milwaukee replacement part that has been sourced from the original manufacturer to be used with hammer drivers, drills, and impact wrenches. The lead wires are used to carry electricity from the switch to the brush card assembly. This item is available as an individual replacement part.

This replacement screw is an authentic OEM sourced hardware designed for use with Milwaukee power tools. It has multiple applications depending on the tool. Please make sure to check appropriate diagrams for correct location and use of this item. Note, one torx screw is included per order.

This is an authentic Milwaukee replacement part manufactured for use with power tools. The special compression spring is used with a variety of different types of power tools. This spring is commonly used to allow flexibility between part assemblies and to prevent jarring between the part assemblies. This compression spring is sold as an ...Read moreindividual replacement part, please see model diagram for part location and usage.

This is a genuine Milwaukee replacement part, it is sold individually. The Milwaukee Belt Hook is attached to the bottom of the handle assembly on the tool model numbers shown below. Its purpose is to hook the tool to your belt when not using the tool. The Belt Kit includes the screw to attach it to the housing of the tool.

It is a high quality OEM sourced hardware that is specially designed for use with Milwaukee impact wrenches. This screw is generally used to secure the belt clip assembly which is sold separately. Please note one durable pan head screw is included per order.

This is an authentic replacement part manufactured for use with Milwaukee impact drivers. The armature assembly is a major component of the electric motor and includes the gear that drives the impact assembly. This armature includes the bearings and this armature is sold as an individual part assembly.

Genuine manufacturer approved replacement part designed for use with Milwaukee impact wrenches. This assembly holds carbon brushes around the armature to provide stable and safe contact. This assembly consists of: plastic holder ring, four (4) metal brush holders with springs and four (4) carbon brushes with lead wires attached. It also i...Read morencludes two (2) screws and two (2) washes used to secure the brush card. To replace this assembly you would need a screwdriver. • First remove screws holding the cover together • Carefully separate housing to gain access to armature and brush holder • Disconnect the wires • Remove the screws holding brush card assembly • Remove old brush holder and install the new assembly • Reassemble and test your tool

This carrying case is an original part from Milwaukee for hex impact drivers. The carrying case allows you to store and carry your hex impact driver. It also provides protection from it getting damaged. To replace the carrying case requires no tools. This part is made of plastic and is sold individually.

The sleeve attaches to the gearcase and the spring. It is made of metal and is sold individually. This authentic item is supplied directly from the original equipment manufacturer for use with Milwaukee impact drivers. A set of pliers may be helpful when replacing this part. Over time this item may break and will need to be replaced.

This is an authentic Milwaukee replacement part manufactured for use with impact drivers. The special front washer helps secure the spring inside the sleeve. This washer is sold as an individual replacement part, but will also come with the gearcase assembly (part 14-30-2657) and the anvil assembly (part 42-06-2657), please see model diagram for any other associative parts.