2651-20 Milwaukee Impact Driver - Parts

This is an original manufacturer sourced replacement part designed for use with Milwaukee impact wrenches. This friction ring helps to secure an o-ring to the anvil. This part is made out of metal and is sold individually.

This is a genuine Milwaukee replacement part, it is sold individually. The Milwaukee 14-46-2012 Brush Card Assembly uses four brushes, whereas most power tools use two brushes. To replace this part you will need to release the spring tension on the brush then place the brush card in its proper position. Worn brushes frequently are the...Read more cause behind a motor running poorly. • Replacing brushes can fix a motor that's operating intermittently. • New brushes can restore a motor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This is an authentic manufacturer sourced replacement part designed for use with Milwaukee impact wrenches. It helps to provide an air tight seal for the gearbox. It is made out of rubber material and it is sold individually. To complete this repair you will need a screwdriver.

This is an OEM Milwaukee Brush Card Assembly, it is sold individually and includes the Lead Wires, Brushes and the Springs. This part uses 4 brushes. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away unt...Read moreil they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems. NOTE: There are two Brush Card Assembly designs. On the original brush card design the red and black wires that go to the switch are soldered on the brush card. On the new brush card design the red and black wires that go to the switch are secured to the brush card with spring washers and screws. The new brush card design is directly interchangeable in tools that have the old brush card design

This genuine manufacturer-sourced component is made for use with Milwaukee power tools. It is an identical replacement for a missing or a faulty 5mm ball that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.

This end cap is an authentic OEM replacement part supplied directly from the manufacturer. It is crafted for use with Milwaukee impact drivers. This end cap provides protection for the service armature assembly. It is designed with several air vents to allow air flow and prevent overheating. It is made of plastic and should be replaced if...Read more it is cracked or damaged. Please note this part is sold individually and requires a screwdriver to install.