2650-059 (D39B) Milwaukee Impact Driver - Parts

The Milwaukee Belt Hook is attached to the bottom of the handle assembly on the tool model numbers shown below. Its purpose is to hook the tool to your belt when not using the tool. To attach the belt hook to the handle you will also need to order part number 06-82-5275 Screw.

This is a genuine Milwaukee replacement part, it is sold individually. The purpose of the 06-82-5275 Screw is to secure the Belt Clip or the Bit Clip on the models shown below. This screw requires a Torx head or a flat head screwdriver.

This service armature assembly is specially designed for Milwaukee impact drivers. It is a genuine item that is supplied from original equipment manufacturer. This assembly includes an armature, a plastic fan, armature bearing and commutator end bearing. It is a key component of an electric motor. It is highly recommended to replace both ...Read morecarbon brushes when replacing an armature. To replace this service armature assembly you will need a screwdriver.

This is an authentic OEM part. It is manufactured for Milwaukee impact drivers. This kit includes one (1) each of: brush card assembly, LED assembly, switch, trigger, printed circuit board assembly (PCBA), and terminal block assembly. It also includes seven (7) screws and two (2) casing halves. Belt hook sold separately. When assembling t...Read morehis kit, firmly place all wires in designated wire traps to avoid pinching wires when reassembling handle halves. One (1) kit is included per order.

This genuine OEM sourced replacement part is specially manufactured for Milwaukee impact drivers. It is part of the tool that allows user to turn it on and off. Mechanical switches over time tend to wear out and may begin to fail eventually requiring replacement. This switch has a durable plastic body and it is sold individually.

This front case sub-assembly is an original part from the Milwaukee manufacturer. Compatible with several impact driver tools, this plastic component is fitted onto the handle assembly. The protective front case sub-assembly is sold individually. You will need a Phillips screwdriver for the installation.

This is an original Milwaukee replacement part. The plastic Forward / Reverse Shuttle is compatible with several impact drivers. This part is fastened onto the switch, providing the user the ability to control the direction of the drill bit. A screwdriver is necessary in making the repair. This part is sold individually.