2601-059 (D36B) Milwaukee Cordless Drill - Parts

Carbon Brush Kit This is a genuine Milwaukee replacement part, it is sold individually. The Milwaukee 14-46-2012 Brush Card Assembly uses four brushes, whereas most power tools use two brushes. To replace this part ... Add to cart

Chuck Screw This is a genuine manufacturer-supplied part that is made for use with Milwaukee hammer drills. It is a special screw that is utilized to secure the chuck. Commonly, screws may need to be replaced due... Add to cart

Service Field This is an authentic replacement part manufactured for use with Milwaukee drills, and drivers. The field is a tube lined with magnets. When the the field is charged with electricity it creates a magne... Add to cart

Handle Halve Set It is a genuine OEM sourced replacement part which is specially designed for Milwaukee drills. This set contains both the right and the left sides of the handle, please make sure to refer to the appro... Add to cart

Bit Holder This is a genuine Milwaukee part. It is sold individually. It attaches to the bottom of the housing on a Milwaukee cordless drill. Its purpose is to hold the small screwdriver bits that are inserted... Add to cart

4-20 X 5/8" Pan HD. Sit. Plastite T-20

Rubber Slug Add to cart

Washer This manufacturer sourced replacement part is designed for use with Milwaukee power tools. It helps to distribute the pressure evenly between two connected parts, this is a standard hardware which has... Add to cart

Forward/Reverse Shuttle Add to cart

Brush Spring - Right The right brush spring is made out of metal. This is an OEM part sourced directly from the manufacturer and used in impact drivers, impact wrenches, saws, and drills made by Milwaukee. This item is so... Add to cart

Brush Spring - Left It is an authentic OEM supplied replacement part that is specially designed for use with Milwaukee power tools. This part is used to keep the brush tight against the armature. Over time when the brush... Add to cart

Belt Hook The Milwaukee Belt Hook is attached to the bottom of the handle assembly on the tool model numbers shown below. Its purpose is to hook the tool to your belt when not using the tool. To attach the bel... Add to cart