22331 - Parts

This is a genuine Murray replacement part that has been sourced from the original manufacturer to be used with walk-behind lawnmowers. The engine stop cable links the control bar and the motor. This cable is used to actuate the engine's governor to control shutting the engine off. This part is sold as an individual item.

It is an authentic OEM part that is specially made for use with Toro and Lawn Boy snowthrowers. This is an identical replacement for a faulty or a missing hardware that was installed on a new unit. It is one of the screws utilized to secure the upper and the lower handles. This high-quality component is made of durable metal and is sold a...Read mores an individual item. Make sure to refer to the appropriate diagrams for your model to ensure the exact location and the correct application. A wrench will be needed to perform this repair.

This washer is designed for use within lawn tractors, lawn mowers, edgers and snow blowers, and is a genuine OEM part that is sold as an individual. This washer has an approximately .54-inch inner-diameter and .81-inch outer-diameter and is made of high-quality metal, but can wear down due to exposure to heat, friction, and fuel. Due to t...Read morehe versatility of this washer, it can be used in a multitude of settings and applications and is not used for one specific purpose, so check the user manual for your equipment for the exact installation locations of this washer.

Keep in mind that this part is sold individually. The torsion spring is made of plastic and attaches to the rear door. A screwdriver, a set of pliers, a socket set, and a nutdriver might all be helpful during the installation of this part. It might break or bend over time and will need replacing. This genuine item is supplied by the original equipment manufacturer for use with Murray lawn mowers.

The Front Baffle is used to direct grass clippings underneath the deck, and attaches underneath the mower deck. This part comes in black and is rated as "Easy" to install. Installation requires a wrench set or socket set. Refer to your make, model and diagrams to check if this part is correct.

This is an authentic replacement part manufactured for use with Toro snowthrowers. The special hex head screw is used with a variety of different snowthrower models and has multiple applications. This screw is available as an individual replacement part, please see model diagram for associative parts.

The slow jet o-ring attaches to the slow jet. It is an authentic OEM sourced item which is specially produced for use with Kohler engines. This item is available as an individual replacement part even though two may be needed. When replacing this part a set of pliers and a screwdriver may be needed. It is made of rubber and will need to be replaced if it becomes lost or broken.

This is a genuine manufacturer-sourced component which is specially made for use with Toro snowthrowers. It is a standard hardware which may have multiple applications. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this screw. Keep in mind it is a high-quality component is ...Read moremade of durable metal and is sold individually. Note, you will need a wrench to secure or remove it.

This is an authentic Murray replacement part that is sourced from the original manufacturer for use with walk-behind lawnmowers. The durable plastic chute connects to the side of the mower's deck and is used to guide the grass clippings as they are discharged. This item is available as an individual replacement part.

This Washer (.40.81 16g Flt) is a black, metal part, requiring a socket set to install. Installation is rated as "Easy". This washer can be used to provide a tight fit between connected components. It attaches onto the bell crank between the adjusting nut and cotter pin. Refer to your make, model and diagrams to check if this model is right for you.