My Orders
22103 (1988) Kenmore Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Original parts lost or discarded by prvious owner
0 of 1 people
found this instruction helpful.
Just replaced drip pans and rings on stove
Other Parts Used:
Was this helpful?
Thank you for voting!
burners were burnt
0 of 1 people
found this instruction helpful.
replaced
Other Parts Used:
Was this helpful?
Thank you for voting!
old and rusted rings and pans
0 of 1 people
found this instruction helpful.
lift stove eyes and replace
Other Parts Used:
Was this helpful?
Thank you for voting!
Old trim rings were rusted and soiled
0 of 1 people
found this instruction helpful.
Too easy to describe. Just lifted out the old rings and popped in the new ones. PartSelect is my go-to source for appliance parts both for my home and my job as maintenance man for residential group homes in my area. Website is easy to use, prices are good, shipping is always surprisingly fast. Thank you.
Other Parts Used:
Was this helpful?
Thank you for voting!
I needed new trim rings around the stove burners
0 of 2 people
found this instruction helpful.
I logged into GE's website, put in my stovetop's requirements for size and type of trim rings, and was taken to partselect's site where I found what I needed. I ordered it and it came in less than a week!
Other Parts Used:
Was this helpful?
Thank you for voting!
drip pan, trim ring were old and burned
0 of 2 people
found this instruction helpful.
just replaced the old for the new
Other Parts Used:
Was this helpful?
Thank you for voting!
original 8" coil burner defective
0 of 2 people
found this instruction helpful.
Took coil mounting assembly off first, then removed or took apart one piece at a time until heater coil was removed. Then installed (with furnished screws)the new coil, following entire process in reverse. 10-15 minutes time.
Other Parts Used:
Was this helpful?
Thank you for voting!
Element had burned out.
0 of 2 people
found this instruction helpful.
The repair was straight forward; Loosen the screw at the tilt mechanism allowing the burner element to come off the stove and then unscrew two electrical connectors freeing the burned element. The installation could have been as easy as reversing the procedure however the lugs on the new element were poorly placed making it difficult to a
... Read more
ttach the two halves of the supplied insulator with the clips that secure the two halves. The insulator required the wires to be bent 90 degrees which further complicated the installation. A dremel and some dielectric grease completed the task to my satisfaction. It should have been a 15 minute job. The new element functions far better that the burned element prior to its demise. I should have changed it long ago. I bought the 8" element as a back-up because this stove has only one large burner. However, given my experience with the improvement of the 6", I'll change it shortly. And knowing I may run into the same installation hiccup, I'll prefit the ceramic insulator.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
burner element had burned out
0 of 4 people
found this instruction helpful.
turn off power at breaker. lift element from stove top lift out drip bowl . remove clips and ceramic cover. unfasten three wires. using new element install three wires to new burner ,clip on ceramic cover then slide burner back in to stove top and install drip bowl turn on power and test
Other Parts Used:
Was this helpful?
Thank you for voting!