22-580 (Type 1) Delta Planer Jointer - Parts

Genuine OEM replacement part This brush is sold individually, 2 are needed for the tools shown below It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can restore a mot...Read moreor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This Ball Bearing is sealed on both sides. This genuine Delta replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduces wear on ...Read morethe tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This genuine item is supplied by the original equipment manufacturer for use with Delta planers. It is one of the special knobs utilized to secure the dust chute assembly. This is an identical replacement for a missing or a faulty component that was installed on a new unit. Keep in mind this high-quality component is sold individually. Pl...Read moreease make sure to refer to the owners manual and the appropriate diagrams of your model for the correct location and application of this hardware.

A genuine item that is supplied directly from the original equipment manufacturer for use with Delta equipment. It is a high-quality replacement for a worn or broken belt that helps to drive the unit, over time material tends to deteriorate and it may begin to crack eventually requiring a replacement to ensure peak performance. Keep in mind this durable rubber belt is sold individually.

This is screw is sourced from the original manufacturer and is intended to be used with planers from Delta and Porter Cable. The pan head screw is used to fasten the knife locking bar to the cutter head assembly. This item is available as an individual replacement part.

This is a set of two high quality steel planer blades that are designed for use with Delta planers. Planer's knives are machined to make very precise cuts, when the knife blades wear down you won't get the level of precision you require. This genuine part is supplied directly from original equipment manufacturer.