216015 Snapper Lawn Mower - Parts

Rod asmy cont w/h

Grip

Cable zone 20s

Support guard

This 0.25-inch-diameter washer with internal lock teeth is an authentic manufacturer replacement fastener used in outdoor power equipment. It has a flanged base, which provides even load distribution and protects the mounting surface from damage during installation and removal. The washer also has inward-facing teeth, providing additional...Read more grip to prevent the secured components from falling off the equipment. Over time, the washer will corrode, crack, or wear down its teeth, leading to equipment instability, noise, and vibrations. Inspect all the washers in your equipment and replace those that are no longer functional. Use a wrench or socket to loosen and remove the old washer, and then position the new one on the mounting surface. Tighten the washer until the flange rests flush against the surface. Each washer is sold individually.

The blade hub spacer goes between the engine pulley and the blade drive hub. This item is made of metal and is sold individually. It is an OEM replacement part for use in Snapper lawn mowers. A wrench might be necessary during the installation of this part. It will need to be replaced if it becomes bent or broken.

This is an OEM part sourced directly from Snapper. The Latch is used to allow height adjustment on the wheels of many models of Snapper Lawn Mowers. This is a fully metal part, and is sold individually. You will need a small monkey wrench or socket wrench to remove the nut and bolt (not included) to replace this part.

Blade Adapter. (25MM ID)