2087 - Parts

This bushing is used with a 1/4-inch pin. This part is found in refrigerators (and sometimes freezers). The bushing provides a bearing surface for the hinge pin that rotates. Every time you are opening and closing your fridge, this part is acting as a bearing and makes it so that the door is swinging back and forth with ease. This bushing...Read more tends to wear down over time and will need to be replaced. You will notice that this part needs to be replaced if your door is off-kilter and not aligned properly. This part is sold separately. This is a genuine part sourced from the manufacturer directly.

This ice dispenser yoke is an inch and a half long. It is made of metal and is used with the ice enclosure of a refrigerator's icemaker assembly.

This egg tray holds fourteen eggs.

This kit comes with ducts, a water fill tube, and the hardware needed to install the icemaker. It replaces the old twist-tray style of icemaker.

Sold Individually.

The speed nut (also referred to as a condenser motor fan nut), fits onto the condenser fan motor. The motor for this fan turns on simultaneously with the evaporator and the compressor motors, so a malfunction in the condenser fan motor could cause your fridge to cycle on and off more frequently or run too warm, or too noisily. Make sure t...Read morehat the speed nut is properly attached and tight. Check the nut for any signs of wear or damage. If the nut is damaged and refuses to tighten, you should replace the part immediately. Remember to unplug your refrigerator before starting this repair.

This cut-to-fit refrigerator door shelf retainer bar comes at twenty-seven inches long. It is made entirely of metal.

This door hinge washer is used between the lower hinge pin and the lower hinge bushing.