20713 - Parts

This is an authentic OEM part from Briggs and Stratton and Toro for use with garden equipment engines. The stop wire connects the ignition coil to the stop switch to ground the spark voltage to the engine block when you release the bail control bar. This part is sold individually. The tool that you will need to replace the stop wire is pliers.

The cylinder head attaches to the cylinder head gasket. It is an authentic replacement part directly sourced from the manufacturer for use in Briggs & Stratton engines and Toro lawn mowers. This item is available individually. A wrench might be needed during the installation process. This part may become broken and will need to be replaced.

It is a genuine item that is supplied by the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. The purpose of these rings is to provide a tight seal between the cylinder and the piston, unfortunately, over time the material will wear out and may begin to fail eventual...Read morely requiring a replacement to ensure peak performance. Keep in mind this high-quality standard set includes three durable metal rings. Please make sure to refer to the appropriate diagrams of your model for the exact location and application of these parts.

This is an authentic replacement part manufactured for use with Briggs & Stratton small engines. This special spring is used to provide compression for the intake and exhaust valves. The spring is available as an individual replacement part, please see model diagram for associative parts.

This item is available as an individual replacement part. The metal screw attaches to the upper handle. A wrench might be required during the replacement of this part. It will require replacing if it breaks or strips. This is an authentic OEM part for lawn mowers made by Toro and Lawn Boy.

It is made of metal and is sold individually. The intake valve goes next to the valve seal. A set of pliers may be required to replace this part. It will require replacing if it bends or breaks. This part is an OEM sourced directly from the manufacturer for use in engines, generators, and lawn mowers made by Briggs & Stratton and Toro.

This is a genuine replacement part manufactured for use with walk-behind lawnmowers. The trailing shield connects to the rear of the mower deck to disperse excess clippings that were not collected by the rear bagger. This trailing shield is sold individually.