20646 - Parts

This authentic item is supplied directly from the original equipment manufacturer for use with Murray edgers and lawn mowers. The ring goes next to the flat washer and is made of metal. When replacing this part a set of pliers might be required during the installation process. It may become bent or broken and will need to be replaced. This item is priced as an individual replacement part.

This hex center lock nut is sourced from the original manufacturer for use in lawn and garden power equipment. It is a hexagon-shaped fastener for bolts/studs that is responsible for the keeping the bolt/studs secure during use. The nut is made of metal and has a diameter of 5/16 of an inch and a thread pitch of 18 internal threads per in...Read morech. Over time the threads in the nut can wear down and the nut itself may crack or break. It is important to replace it as soon as necessary to avoid damaging your equipment. Use a socket or wrench to remove the old nut and thread the new one on. Make sure to order the correct number of nuts for your equipment as each nut is sold individually.

This washer is designed for use within lawn tractors, lawn mowers, edgers and snow blowers, and is a genuine OEM part that is sold as an individual. This washer has an approximately .54-inch inner-diameter and .81-inch outer-diameter and is made of high-quality metal, but can wear down due to exposure to heat, friction, and fuel. Due to t...Read morehe versatility of this washer, it can be used in a multitude of settings and applications and is not used for one specific purpose, so check the user manual for your equipment for the exact installation locations of this washer.

Keep in mind that this part is sold individually. The torsion spring is made of plastic and attaches to the rear door. A screwdriver, a set of pliers, a socket set, and a nutdriver might all be helpful during the installation of this part. It might break or bend over time and will need replacing. This genuine item is supplied by the original equipment manufacturer for use with Murray lawn mowers.

This Washer (.40.81 16g Flt) is a black, metal part, requiring a socket set to install. Installation is rated as "Easy". This washer can be used to provide a tight fit between connected components. It attaches onto the bell crank between the adjusting nut and cotter pin. Refer to your make, model and diagrams to check if this model is right for you.

This is a genuine Toro replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal hex nut is part of the mower\\\'s deck assembly. This nut is used to secure the blade pulley to the spindle shaft assembly. This part is sold individually.

Keep in mind this part is made of metal and is sold individually. The washer goes next to the extension spring. It may require a wrench during installation. Over time this part may break and will need to be replaced. This authentic item is supplied directly from the original equipment manufacturer for use with lawn tractors and lawn mowers made by Murray, Briggs & Stratton, Snapper, and Simplicity.

The retainer attaches to the idler arm support. This genuine item is supplied by the original equipment manufacturer for use with tractors and rear engine riders made by Snapper, Murray, and Simplicity. It is made out of metal and is sold individually. During the installation process, a wrench set might be needed to replace this part. Over time this part may break and will need to be replaced.

This replacement screw is supplied directly from the original equipment manufacturer for use with Murray walk-behind lawn mowers. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams for correct location and use of this part. This is a high-quality co...Read moremponent which is made of durable metal and it is sold individually, the washer is included.

The pinion gear attaches to the height adjuster. It is a genuine item that is supplied by the original equipment manufacturer for use with Briggs & Stratton generators and Murray lawn mowers. This part is made of metal and is sold individually. A wrench and set of pliers may be helpful when replacing this part. It will need to be replaced if it breaks or becomes stripped.