20608 Lawn Mower - Parts

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with walk-behind lawnmowers. The metal bolt is used to secure the blade to the blade adapter. A hex socket wrench is needed to install this part. This item is available as an individual replacement part.

This is an OEM part source directly from the manufacturer. The blade adapter is commonly found in lawn mowers from Murray. This part is made of metal, and is used to connect the mower blade with the mower deck. You will require a wrench when replacing this item. The blade adapter is provided as an individual replacement part.

Washer.50.99.03 flat

The drive pin attaches to the pinion gear and the washer. This part is an OEM from Murray for use in lawn mowers. It is made out of metal and is sold individually. It may require a set of pliers and a socket set during installation. This part will need to be replaced if it breaks or bends.

This is the special bolt-hex which is utilized to secure the mower blade. It is an identical replacement for the hardware that was installed on a new equipment. Check the owner\'s manual and the parts diagrams for your specific model to ensure the correct replacement procedure. This high-quality bolt-hex is made of durable metal and is so...Read moreld as an individual item. It is supplied by the original manufacturer for Murray and Snapper lawn mowers. Note, a wrench will be needed to secure or remove it.

This is an original Murray replacement part. The rear idler pulley is commonly found in lawn mowers. This part is made of high-quality plastic, and is designed to provide the appropriate amount of tension to the drive belt. You will require a wrench when replacing this item. This part is sold individually.

This part is an OEM from Murray for use with Lawn Mowers. The engine stop cable stops the engine when you let go of the handle. The most common reason for replacing the control cable is if it is broken, causing the brake to not release even when the lever is pressed. This part is sold individually. The tool that you will need to replace the engine stop cable is pliers.