2032 - Instructions

Also replaced fuel tank , the built in fuel shut off started leaking , had to replace the tank. Ordered a new one Briggs & Stratton original equipment fit perfect . This is a 25 year old Briggs & Stratton lawn mower 3.5 HP, Runs perfect, starts by the 2nd crank every time. First time I ever had to spend money on it since I bought it new i ... Read more n 1991

Inspected/removed fuel lines and found signs of leak. Removed and inspected carburetor and found that seals and gaskets were toast. Replaced said seals with ones from the kit that fit and replaced fuel lines.

Would be nice to have a fuel line kit with the big fuel line (tank to carb) and the little one (carb to engine) together ... Read more with all the necessary clamps.

No repair, lol! Just a perfect fit for my ignition :). I bought two in case my grandson gets curious again.

Disconnected spark plug wire laid lawn mower in side removed blade bolt took off old blade put new blade on tightened it reconnected spark plug wire

Everything went very easy and was done in no time. After I put on new part, mower started right up.

Tip mower onto side, raising side to be repaired. Empty gas tank if possible or use rags to prevent gasoline drips onto clean surfaces.

Remove wheel using a 1/2" socket.
Remove wheel height assembly with 1/2" socket and open end wrench to hold nut below the deck.
Position new spring arm over the slot on wheel height ... Read more assembly plate. Check opposite side to verify correct orientation if needed.
Remove plastic cover from old lever using a small flat blade screwdriver. Slip onto new lever.
Replace wheel height assembly.
Replace wheel.

The repair did not happen. The item number PS9294414 was the wrong
part. When I looked up the model number of 126-T02-0625-B1 engine after I tried to install it. The PartSelect answer was that they no longer had parts for 126-T02-0625-B1 engine any more. Do I need to send the
Spring-Choke Return and get my refund back. If so h ... Read more ow do I do it.

I took off the old blade adapter and put the new one on. It literally requires removing one bolt. Unfortunately, once I started and ran my mower for a few minutes it blew up and left a charred patch of lawn. The underside of the mower is mangled metal and unusable now. The repair, though, was super easy!