20135 - Parts

This replacement gasket is used to create an air tight seal between the crackcase and the cylinder assembly. Over time gaskets tend to deteriorate and will eventually need to be replaced. It is an authentic OEM sourced item that is designed for use with Briggs and Stratton engines. This item is made from high quality composite material and it is sold individually.

Sold Individually. This knob takes a double-flat shaft.

This item is a genuine OEM replacement part that is intended to be used with lawnmower engines from Briggs & Stratton and Toro. The metal needle is used as a valve that regulates the amount of fuel sent to the carburetor as the bowl fills and drains. This item is available as an individual replacement part.

The stop switch is made of plastic and metal and helps to turn off the device. This is an authentic replacement part that is sourced from the original manufacturer for use with engines, generators, snowthrowers, and blower-vacuums made by Toro, Murray, and Briggs & Stratton. This part is available individually. During the installation pro...Read morecess, a wrench set and wire stripping pliers might be needed to replace this part. It may become bent or broken and will need to be replaced.

This flywheel puller is designed for servicing larger small engines by safely removing tightly seated flywheels without stressing the crankshaft or damaging ignition components. Constructed from heavy-duty steel and engineered to apply even pulling force, it makes accessing the magneto, crankshaft key, or ignition system straightforward d...Read moreuring repairs or overhauls. Built to OEM specifications for durability and precise fit, it’s a reliable tool for maintaining lawn mowers, generators, and pressure washers with compatible engines.

This replacement screw is a genuine hardware that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. This part is made of high-quality metal and it is sold individually, you will need either a wrench or a flat-head screwdriver to install or remove it.

There are 4 wires that are included in this kit

This is the nut that has a hole in the center and is attached to the drain tube that leads the grease/oil from the grill pan.