20133 - Parts

This flexible duct stretches out to eighteen inches, and is six inches in diameter. It is made of aluminum, and is coated in a black substance.

The stop switch is made of plastic and metal and helps to turn off the device. This is an authentic replacement part that is sourced from the original manufacturer for use with engines, generators, snowthrowers, and blower-vacuums made by Toro, Murray, and Briggs & Stratton. This part is available individually. During the installation pro...Read morecess, a wrench set and wire stripping pliers might be needed to replace this part. It may become bent or broken and will need to be replaced.

This flywheel puller is designed for servicing larger small engines by safely removing tightly seated flywheels without stressing the crankshaft or damaging ignition components. Constructed from heavy-duty steel and engineered to apply even pulling force, it makes accessing the magneto, crankshaft key, or ignition system straightforward d...Read moreuring repairs or overhauls. Built to OEM specifications for durability and precise fit, it’s a reliable tool for maintaining lawn mowers, generators, and pressure washers with compatible engines.

This replacement screw is a genuine hardware that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. This part is made of high-quality metal and it is sold individually, you will need either a wrench or a flat-head screwdriver to install or remove it.

There are 4 wires that are included in this kit

This is the nut that has a hole in the center and is attached to the drain tube that leads the grease/oil from the grill pan.

A zip tie, also known as a cable tie or a wire tie, is a fastening device that holds wires or tubing together. If a machine has wires or tubing that are easily shifted, you need to hold them tightly together using a zip tie. It is a flexible, plastic strip that has serrated teeth and a locking mechanism. If the zip tie is damaged, it shou...Read moreld be replaced. Freely moving wires may rub against surfaces, causing them to break over time. Zip ties are single-use and may not be reused after they are removed from a machine. To release the locking mechanism, you will need to insert a small flat tool into the head of the zip tie, between the tongue and the serration, and depress the bar. You can then pull the teeth out of the mechanism to loosen the cable tie. This part is produced by the original equipment manufacturer and is sold individually.

This is an authentic Briggs & Stratton replacement part, sourced from the original manufacturer for use with small engines. The special air cleaner cover is commonly used to secure the air filter to the air cleaner base. This air cleaner cover is available as an individual replacement part, please see model diagram for associative parts.

This engine ring set is a genuine OEM replacement designed for small engine applications. It helps seal the cylinder properly to maintain compression, reduce oil consumption, and restore smooth, efficient engine operation. Ideal for engine rebuilds or repairs, this ring set should be replaced when wear causes power loss, excessive oil use, or reduced overall performance.

This washer is well under an inch in diameter, and is made entirely of metal.