2012 - Parts

Cap-fuel w/gauge

This OEM Washer (j.39-2.2 11G Fl), is a silver, metal part, requiring a wrench or socket set to install. Installation is rated as "Easy". This washer can be used as a spacer between the bottom of the blade and the blade bolt. It attaches on the blade bolt to support the blade. If broken due to fatigue/damage, you may hear a rattling sound...Read more underneath the cutting deck and should replace the part. Refer to your make, model and diagrams to check if this model is right for you.

This flange nut is designed for use in lawn and garden equipment. It is an OEM replacement part with a diameter of 0.375 inches and a thread pitch of 16 threads per inch. The nut has a ring-shaped extension on one end, known as a flange which helps to evenly distribute the clamping force of the nut and provide a more secure hold. Addition...Read moreally, the flange eliminates the need for separate washers and reduces the risk of abrasion on the surface being fastened. It is normal for the nut to corrode, crack, or for the threads to wear down over time. To replace the flange nut, unthread it from the fastener, and insert and secure the new one using a socket/wrench. Each sold individually.

Seal-oil 0.875id x 1.

This is an authentic replacement part, sourced from the original manufacturer for use with lawnmower engines. The special seal is commonly used to prevent oil leaks at the connection between the axle and the transmission case assembly. This item is available as an individual replacement part, please note two seals may be required.

This is an Authentic OEM Approved replacement part designed for use with Makita Planers/Jointers. This part is made out of Metal and it is Sold Separately. This part helps to secure the Roller and allows it to spin smoothly. To replace this part you would need Retaining Ring Pliers, Screwdriver and a Set of Wrenches.

This Washer (.40.81 16g Flt) is a black, metal part, requiring a socket set to install. Installation is rated as "Easy". This washer can be used to provide a tight fit between connected components. It attaches onto the bell crank between the adjusting nut and cotter pin. Refer to your make, model and diagrams to check if this model is right for you.

This is an authentic replacement part manufactured for use with Murray walk-behind lawnmowers. Lawnmower blades can wear out over time causing the blade to tear and fray the grass blades. Replacing a worn mower blade can provide a cleaner cut that can improve the look of the lawn. This blade is available as an individual replacement part.

Seal oil

This is a ten (10) pin sprocket assembled by original manufacturer. It is used in some Makita planers. Sprockets engage gears and/or chains. These parts are designed to be replaced fairly often due to wear and tear from regular use. Sold individually.