20073 - Instructions

First took photos of the current hookup for referencing. Cleaned the area. Removed the gas tank for easy access to the fasteners and hookups. Everything came undone fairly easy. Cleaned the area some more. Installed all new parts and the form and fit was perfect. Quite the upgrade. Put it all back together. Primed the carb. After abo ... Read more ut 10 pulls the edger started right up. No gasoline leaks to be found. Shut down. Started on the first pull. I’m good to go.

The hub that the mower blade mounts to was brokenPut the new Harbonne played and played securing flange bolted it up

I pryed the apart the torsion spring lever from the handle with a large screw driver. It wasn't easy putting it back, but it worked

I lost two of the screws that hold the plastic Lawn Boy cowling to the Tecumseh lv195ea engine. I just replaced the lost screws with the newly ordered screws.

Tip mower onto side, raising side to be repaired. Empty gas tank if possible or use rags to prevent gasoline drips onto clean surfaces.

Remove wheel using a 1/2" socket.
Remove wheel height assembly with 1/2" socket and open end wrench to hold nut below the deck.
Position new spring arm over the slot on wheel height ... Read more assembly plate. Check opposite side to verify correct orientation if needed.
Remove plastic cover from old lever using a small flat blade screwdriver. Slip onto new lever.
Replace wheel height assembly.
Replace wheel.