20021 - Parts

This durable nylon starter rope is an authentic OEM supplied replacement part that is specially produced for use with Briggs and Stratton engines that are commonly installed on Toro lawn and garden equipment. When the rope is pulled to start the engine, it is returned back into the starter pulley by means of the starter spring. One starte...Read morer rope is included per order, please note the handle grip and other parts are all sold separately.

It is an authentic Toro hardware. The washer-clutch is supplied from the original equipment manufacturer for use on lawn mowers. It helps to engage the pinion gear which is an important component that drives the wheel assembly. If the motor runs but the drive wheel is not spinning, a broken or worn washer-clutch may be the reason. To ensu...Read morere the exact location and the correct application of this item, refer to the appropriate diagrams of your model. Note, one durable plastic washer-clutch is included. You will need a wrench set to remove and resecure the wheel when replacing this hardware.

The Handle (or Knob Handle) is a black, plastic part which is rated as "Easy" to install by customers. It attaches onto the handle, so you can quickly release to fold down the handle bar. If the part is visibly broken (due to wear/fatigue), it should be replaced. Refer to your make, model and diagram to check if this is the right part for you.

This genuine replacement part is supplied from original equipment manufacturer. It is a commonly used item on Toro lawn mowers. The purpose of this shoulder bolt is to secure a wheel to the axle. This bolt has a hex head which requires a wrench to secure. Includes one (1) bolt per order.

This authentic item is supplied directly from the original equipment manufacturer for use with engines, outboard motors, portable generators, snowthrowers, and lawn mowers made by Briggs & Stratton and Toro. The o-ring seal attaches to the dipstick. When replacing this part a socket set might be required during the installation process. I...Read moret is made out of rubber and will need to be replaced if it breaks. This part is available as an individual replacement.

This is an authentic Toro replacement part that has been sourced from the original manufacturer to be used with walk-behind lawnmowers. The plastic pivot stop attaches to the upper handle and is used prevent the control bail from pivoting too far and breaking the cable. This item is available as an individual replacement part.

This is an authentic replacement part manufactured for use with small engines. The gasket is used to seal the cylinder intake. It is recommended to replace gaskets when servicing the engine to ensure proper seals when the parts are reassembled. This gasket is sold as an individual replacement part, please see model diagram for associative parts.

This is a genuine Briggs and Stratton part that has been OEM sourced to ensure a high-level of quality. The metal governor spring is intended to be used with small engines. This spring is used to return the throttle lever after a change in the motor's output based on the load controlled by the governor. This item is available as an individual replacement part.

It is an authentic OEM supplied exhaust gasket that is designed to provide an air tight seal between the muffler and the exhaust pipe. This part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. Over time gaskets tend to shrink, become brittle and crack eventually requirin...Read moreg replacement. It is made of high-quality composite material and it is sold individually.

This is an authentic OEM sourced part that is intended to be used with walk-behind lawnmowers from Toro and Lawn Boy. The wheel interconnects with the transaxle's pinion gear and is used to drive the mower when using the self-propel feature. This item is available as an individual replacement part.

This part is an OEM sourced directly from the manufacturer for use in Briggs & Stratton engines and Toro lawn mowers. The air cleaner screw attaches to the air cleaner. It may require a wrench during installation. Over time this screw may become stripped or broken and will need to be replaced. Keep in mind this part is made of metal and is sold individually.