20021 - Parts

It is a genuine item that is supplied by the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. The purpose of these rings is to provide a tight seal between the cylinder and the piston, unfortunately, over time the material will wear out and may begin to fail eventual...Read morely requiring a replacement to ensure peak performance. Keep in mind this high-quality standard set includes three durable metal rings. Please make sure to refer to the appropriate diagrams of your model for the exact location and application of these parts.

This is an authentic replacement part manufactured for use with Briggs & Stratton small engines. This special spring is used to provide compression for the intake and exhaust valves. The spring is available as an individual replacement part, please see model diagram for associative parts.

This is an authentic replacement part manufactured for use with walk-behind lawnmowers. The knob is threaded and used to secure the side cover or side discharge chute. This knob does not require tools to install and is sold as an individual replacement part.

It is made of metal and is sold individually. The intake valve goes next to the valve seal. A set of pliers may be required to replace this part. It will require replacing if it bends or breaks. This part is an OEM sourced directly from the manufacturer for use in engines, generators, and lawn mowers made by Briggs & Stratton and Toro.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Toro snowthrowers. This is an identical replacement for a missing or faulty pin-hinge that is utilized to secure the deflector, please make sure to check the appropriate diagrams of your model for the correct location and application of th...Read moreis hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.

This is an original replacement part manufactured for use with small engines on outdoor power equipment. The starter handle is tethered to the starter rope and used to pull start the engine. This starter handle is sold as an individual replacement part, please see model diagram for associative parts.

This is a genuine replacement part manufactured for use with walk-behind lawnmowers. The trailing shield connects to the rear of the mower deck to disperse excess clippings that were not collected by the rear bagger. This trailing shield is sold individually.

This is a genuine manufacturer-approved component which is specially designed for use with Toro lawn mowers. The purpose of this pulley is to secure and apply tension to the belt. It provides an identical replacement for a missing or a faulty part that was installed on a new unit. This high-quality pulley half is made of durable metal and...Read more is sold individually. Note, the other half is sold separately. Please make sure to check the owners manual and the appropriate diagrams of your model for the correct location and application of this component.