All Installation Instructions for Husqvarna Lawn Tractor 1848XPB

Wheel bushings were bad

29 of 48 people found this instruction helpful.

Anthony from OLIVEHILL, TN
Easy
15 - 30 mins
Pliers, Screw drivers

Removed old clip removed rim from tractor, removed grease fitting on rim, took hammer and screw driver knocked out old bushing turned rim over knocked out other bushing. Press in new bushings reinstalled grease fitting slide tire back on tractor, put retaining washers on then locking clip put on dust cover grease at grease fitting. Repeat ... Read more

Read less

Other Parts Used:

Lawn Mower Ring Clip

Cap Axle Black 1 50 x 1 00

Was this helpful?

The tie rod on my 20 year-old lawn tractor snapped.

1 person found this instruction helpful.

James from CEDAR SPRINGS, MI
Very Easy
Less than 15 mins
Wrench set

I used two wrenches, unscrewed both ends of the old tie rod and it fell out. In nearly no time, I had the new one in. After finding the right end wrenches, I don't think I had more than 10 minutes into the project. Easiest repair I have done on anything in a long time!

Was this helpful?

Take the wheel off. Place the key in the slot. Put the wheel back on.

7 of 19 people found this instruction helpful.

Gary from PILESGROVE, NJ
Very Easy
Less than 15 mins

Just described it.

Was this helpful?

Broken v-belt for drive

2 of 7 people found this instruction helpful.

Paul from ROCKTON, IL
Easy
30 - 60 mins
Pliers, Wrench set

I returned the belt because it was the wrong part. Ordered the correct belt from another source. After that the replacement went well and I crossed off Parts Select from my list.

Was this helpful?

Front wheels, too much end play

10 of 39 people found this instruction helpful.

Frederick from BINGHAMTON, NY
Very Easy
Less than 15 mins

Shimmed the wheels out on axle.. No more slop.

Was this helpful?

1848XPB (YTH 954567260 -2001-05) Husqvarna Lawn Tractor - Instructions