1840 - Parts

This is an original replacement part sourced directly from the manufacturer. The screw is commonly found in Toro snowthrowers, lawn mowers, and tillers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to the...Read more parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The screw is sold as an individual replacement part.

This is an original replacement part manufactured for use with small engines on outdoor power equipment. The starter handle is tethered to the starter rope and used to pull start the engine. This starter handle is sold as an individual replacement part, please see model diagram for associative parts.

When the lower panel of a gas grill rattles or pulls away from the cabinet, worn mounting hardware may be responsible. This hardware pack provides the fasteners and washers needed to hold a compatible bottom panel securely in position. Check for loose screws, damaged threads, missing washers, panel distortion, and rust around the mounting...Read more points before ordering. A badly corroded panel or frame may also require replacement. Use the grills full model and serial details to confirm fit. Shut off and disconnect the fuel source, then wait until every surface is cool. Support the panel during installation and start all screws loosely before tightening them evenly.

This is an authentic Toro replacement part that has been sourced from the original manufacturer to be used with lawnmowers. The gasket is used to seal the connection between the crankcase and the crankcase cover. This item is available as an individual replacement part.

This is an Original Weber replacement parts used for some of their Grills. This set contains 4 Flavorizer Bars. The purpose of bars is to direct grease and drippings away from the burner tubes, which cuts down on flare ups tremendously. An extra benefit of Flavorizer Bars is that they help add that "cooked on a grill" flavor to your food....Read more Bars rust is the combination of heat and moisture and should be replaced of they are damaged our have holes.

The carburetor bowl attaches to the carb float. It is made of metal and is sold individually. This part is an OEM from Oregon, Husqvarna, and Toro for use in engines and snowthrowers. When replacing this item a set of pliers and a socket set might be required during the installation process. This part will need to be replaced if it breaks.

This is an authentic replacement part sourced directly from the manufacturer. The tension spring is commonly found in Toro snowthrowers. This part is made of metal, and is used to provide tension between the throttle crack screw and the carburetor. You will require a screwdriver when replacing this part. This item is sold individually.