1808 - Parts

The bushing is made of white plastic and is for a 3/8-inch pin. This bushing is part of your refrigerator assembly and is found on the top of the door. A worn-out bushing will cause your door to become misaligned. If you notice the fridge door is not opening or closing easily it could be due to the bushing being damaged. You will need to ...Read moreremove the entire refrigerator door by removing the upper hinge first. This will give you access to the bushing. This is a genuine OEM part that comes right from the manufacturer.

This drier may also be known as a refrigerator ultra-violet dye drier or a filter drier and is meant to be used with your fridge. This piece is a filter for the refrigerant that moves through the refrigerators sealed-system. The most common reason you will need to replace the filter is if your fridge/freezer is not starting. You should co...Read morensider having this piece installed by an appliance repair technician that is trained and licensed. Installing this part requires specialized knowledge and tools. The installation will require the service technician to recover and recharge the refrigerant in the refrigerators sealed-system.

This lower hinge pin is almost an inch long. It is made of metal.

The Fuel Line Clamp is a metal, individually sold part which clamps onto the fuel line, securing it to a port and preventing leaks. Installation is rated as "Easy" by customers and will require pliers and a screwdriver. If broken due to wear/fatigue/damage, there may be a fuel leak and the part should be replaced. Refer to your make, model and diagrams to ensure this is the correct part.

This filter, also known as a water inlet screen, is designed for use with pressure washers and has a 1-inch diameter (including the surrounding rubber housing). The filter itself is made of mesh and is sold as an individual part that filters dirt and debris from entering your pressure washer. It is recommended that this part is routinely ...Read moreinspected to keep your equipment running smoothly and to prevent a damaged filter from allowing dirt into your equipment. This part sits in-between the hose from your home and the pressure washer itself and is a genuine OEM part that requires no tools to replace or install.

This item is an authentic OEM sourced O-ring kit that replaces worn or damaged O-rings for the gun, hose and wand.Unfortunately, over time o-rings will wear out and they may begin to crack eventually requiring replacements. Refer to the appropriate diagrams for your model to ensure the correct replacement procedure. A screwdriver and a wr...Read moreench set might be needed to take apart and reassemble the equipment. Note, this kit is sold as an individual item.

Carburetor Kit

This is a genuine replacement part manufactured for use with outdoor power equipment. This flanged hex head screw has several applications, please see model diagram for part use and location. This screw is available as an individual replacement part.

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.