1805B Makita Planer Jointer - Overview

This is a genuine Makita replacement part that includes two carbon brushes with wire leads attached. Carbon brushes are essential components in power tools and are among the most commonly replaced parts due to regular wear from friction. Over time, worn brushes can cause a motor to run poorly, operate intermittently, or lose electric brak...Read moreing power. Replacing them can often restore your tool’s performance. A worn brush may appear cracked, pitted, burned, or worn down near the wire lead. It’s always best to replace both brushes at the same time, even if only one shows signs of wear. When installing new brushes, be sure to inspect the armature for any damage such as burns or cracks, which could indicate more serious motor issues.

Genuine Makita replacement part, this item is sold individually. The purpose of the Brush Holder Cap is to retain the brush in the brush holder. This Brush Cap is used on all the Makita models listed below. It is removed by using a slotted screwdriver Do not press too hard when removing the cap they do have a tendency to break.

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutters. The washer has multiple applications based on the model of the power tool. It is recommended to review your model's diagram to verify this washer's compatibility. The washer is sold individually.

Genuine Makita replacement part. This phillips pan-head screw includes a washer. It is sold individually.

This is an authentic Makita replacement part. The flat washer is designed by the manufacturer for use in power tools such as chainsaws, rotary hammers, and coil nailers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different washers used in the mach...Read moreine. Refer to the parts diagram to be sure of ordering the correct part. You may require an Allen wrench or hex key when replacing this part. This item is sold individually.

This replacement flat washer is a genuine OEM part, not an aftermarket equivalent. It is specially manufactured for use with Makita power tools. This standard hardware has multiple applications depending on your tool. For correct location and use please refer to appropriate diagrams. This metal washer is sold individually.