My Orders
1662 - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The copper fitting on the chemical injection broke.
12 of 17 people
found this instruction helpful.
-
Carl from ARCADIA, FL
- Very Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
I order the part from this site and received it within a week. the only problem was that spring was missing out of the sealed bag. NO PROBLEM!!! I cut a ball point pen spring to fit and everything works just fine. You just have to remember to put the spring in first, then the ball bearing and then the rubber o-ring.If you put them in back
... Read more
wards you pressure will fed directly into your chemical container!!
Read less
Was this helpful?
Thank you for voting!
remove and replace
10 of 24 people
found this instruction helpful.
-
Perry from Flushing, NY
- Really Easy
- Less than 15 mins
very easy remove the bad bulb install the new one
Was this helpful?
Thank you for voting!
Fluorescent lamp bulb
1 person
found this instruction helpful.
-
Danial from HILLSBORO, TX
- Really Easy
- 15 - 30 mins
-
Screw drivers
Unscrew the metal rim and remove the glass window. Remove the old bulb by twesting the bulb towards you. Place the new bulb's pins into the slots and twest away from you. Place the metal rims back in place and screw them down.
Was this helpful?
Thank you for voting!
dropped & broke the oven light bulb cover
1 of 2 people
found this instruction helpful.
-
joseph from san jose, CA
- Really Easy
- Less than 15 mins
popped the new one on!
Was this helpful?
Thank you for voting!
Solenoid failed due to excessive heat.
0 of 1 people
found this instruction helpful.
-
Joseph from Martins Creek, PA
- Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers
Removed back panel. Removed the defective solenoid on its bracket. Replaced it with the new door latch solenoid. This was relatively easy. Replaced the back panel. Tested self cleaning feature. Everything worked fine. I have preformed this same repair once before.
Was this helpful?
Thank you for voting!